So if this has been posted I cant find it......
Moderators: Helpinators, Moderators
So if this has been posted I cant find it......
Bolting up a '02 WRX pressure plate/clutch cover and I am a bit puzzled as to how these are to line up? Everything Ive read says that the cover and the flywheel will have matching marks to show the proper balance when mating the two components. I found a dimple on the cover but no corresponding mark on the flywheel. All of the how to posts dont indicate that a spacific alignment needs to be made. Am I searching needlessly or is there a obvious way to determine correct alignment that I am just too dense to see on my own? Any help is appreciated.
1992 SS 5MT
She's growing faster in her old age!
She's growing faster in her old age!
From the experience with my setup....there isn't any specific alignment marks unless you buy the flywheel, clutch, & pp together so that they have been balanced together.
So...just stick it on there and go.
So...just stick it on there and go.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
-
555BCTurbo
- Knowledgeable
- Posts: 3335
- Joined: Wed Feb 16, 2005 9:40 pm
- Location: Oregon
Legacy777 wrote:From the experience with my setup....there isn't any specific alignment marks unless you buy the flywheel, clutch, & pp together so that they have been balanced together.
So...just stick it on there and go.
+1
Nick
1987 Audi 4000CS quattro...soon to be 20VT
1994 Dodge Ram 2500 4x4 CTD, #11 plate, 30 psi, Scotty II intake, 4" exhaust
1987 Audi 4000CS quattro...soon to be 20VT
1994 Dodge Ram 2500 4x4 CTD, #11 plate, 30 psi, Scotty II intake, 4" exhaust
-
AWD_addict
- Fifth Gear
- Posts: 2774
- Joined: Sun Nov 23, 2003 12:22 am
- Location: Western WA!