Clutch problems

dzx · Post by **dzx** » Sun May 27, 2007 11:22 pm

I recently replaced my ceramic clutch with a regular organic one that I had laying around. When I drove it, the clutch felt like it wasn't disengaging all the way and was having problems getting into first and reverse. I adjusted the clutch cable but even as tight as I could get it, it was still having problems. The ceramic clutch was not having problems disengaging before I took it out. But it would make a grinding noise when I engaged it. Not sure if that was somehow related to the torn up input shaft seal or what. So I just decided to replace it.

I pulled the transmission to replace the input shaft seal but it's ready to go back in and I really don't want to mess with the clutch again any time soon. So my question is what could be causing this? It almost feels like the clutch is too thick. One of the pins holding the throughout bearing to the clutch fork was gone when I opened it, but the clutch wasn't having problems disengaging at that time.

Here's what I could think of.

1) I should use the valco pressure plate for the clutch instead of the exedy stage one pressure plate that is on it now.

2) I overtightened the pressure plate to the flywheel...this seems like a good possibility to me..

3) Something else is wrong..

4) I should just clean up the ACT 6 puck disc and put it back in and it shouldn't grind when engaged since the seal is fixed....

any ideas would be helpful.

dzx · Post by **dzx** » Mon May 28, 2007 11:03 am

Fixed it.

gto7419 · Post by **gto7419** » Mon May 28, 2007 3:36 pm

What was wrong?

entirelyturbo · Post by **entirelyturbo** » Mon May 28, 2007 6:34 pm

It sounds like he adjusted it the wrong way. Tightening the cable makes the clutch release later, loosening it makes the clutch release earlier.

dzx · Post by **dzx** » Mon May 28, 2007 10:43 pm

maybe with a different type of clutch setup. My car is setup just like any other early legacy. Tightening the cable causes the clutch to release higher and gives less play in the pedal.

The problem was the disc was in backwards.

jefferson · Post by **jefferson** » Fri Jun 15, 2007 4:32 am

After reading about your problem and what fixed it I am thinking that is exactly what is wrong with my car. Mine is very hard to get into 1st and reverse. I'll have to check that when I pull the tranny out for some other problems I am having.

Jeff

dzx · Post by **dzx** » Sat Jun 16, 2007 12:13 am

Hopefully you get it figured out.

BAC5.2 · Post by **BAC5.2** » Sun Jun 17, 2007 1:12 pm

Lol, I didn't think the pressure plate would bolt up with the clutch disc in backwards.

I hate those kinds of mistakes!

dzx · Post by **dzx** » Mon Jun 18, 2007 6:45 am

the flywheel was grabbing the springs so there were some nice metal shavings in there but yeah, i felt stupid.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

Clutch problems

Clutch problems