tapping EJ22T heads for Cyl Temp Sensor.

Heads, valves, pistons, rods, crankshaft, etc...

Moderators: Helpinators, Moderators

Post Reply
scuzzy
Third Gear
Posts: 775
Joined: Sun Feb 20, 2005 1:53 am

tapping EJ22T heads for Cyl Temp Sensor.

Post by scuzzy »

Need to know the best location you think would be to tap an EJ22T head (which one is important) for a cylinder head temp sensor; since our plug wells are deep the ones that go around the spark plug sensors won't work for me, so I need to do some shallow drilling (quarter inch at most is good)

The object is to not drill through anything, I just need to drill deep enough to run a tap into the spot and still have metal contact on the rear of the drilled area.

I'm thinking somewhere around Cyl 3, since I hear it has fueling/coolant issues - but I don't know what the best spot is on the head without running into a coolant or oil line, or messing up the rockers/camshafts.

your opinions/facts are greatly appreciated in this matter. thanks :)
91 Legacy Wagon, Total Rally Car.

#82 M4 TRSCCA Rallycross

http://www.youtube.com/mobilepolice/
Top
scuzzy
Third Gear
Posts: 775
Joined: Sun Feb 20, 2005 1:53 am

Post by scuzzy »

bump, no clues huh? just going to have to start drilling and hope I don't hit something important huh? :(
91 Legacy Wagon, Total Rally Car.

#82 M4 TRSCCA Rallycross

http://www.youtube.com/mobilepolice/
Top
Post Reply

Return to “Engine”