Heads, valves, pistons, rods, crankshaft, etc...
Moderators: Helpinators, Moderators
-
chochocho
- Second Gear
- Posts: 335
- Joined: Fri Jan 20, 2006 8:06 pm
Post
by chochocho »
hello all,
i am looking to replace the hoses on the oil cooler hoses and looking for aftermarket type hose.
the hose sizes are 11.5x18.5 and 11.5x18.5x38
what does the numbers stand for?
thanks in advance.
-
vrg3
- Vikash
- Posts: 12517
- Joined: Sun Nov 03, 2002 2:13 am
- Location: USA, OH, Cleveland (sometimes visiting DC though)
-
Contact:
Post
by vrg3 »
All I know is the first number is the diameter in millimeters.
"Just reading vrg3's convoluted, information-packed posts made me feel better all over again." -- subyluvr2212
-
rrhartjr
- In Neutral
- Posts: 22
- Joined: Mon Mar 03, 2008 3:53 am
Post
by rrhartjr »
11.5x18.5 is probably inner diameter and outer diameter
11.5x18.5x38 specifies the length, i suspect
-
skid542
- Fifth Gear
- Posts: 2857
- Joined: Fri Dec 26, 2003 6:37 am
- Location: North Idaho
Post
by skid542 »
When I did my tranny cooler install I used 3/8" line and it seems to be working so far. Not quite as tight of a slip fit but still snugs down hard.
FWIW.
Lee
93' SS, 5mt swapped, 182k, not stock...
96' N/A OBW 5sp, 212k, Couple mods... RIP
99' N/A OBW, 4eat, mostly stock.
-
vrg3
- Vikash
- Posts: 12517
- Joined: Sun Nov 03, 2002 2:13 am
- Location: USA, OH, Cleveland (sometimes visiting DC though)
-
Contact:
Post
by vrg3 »
1/2" hose fits the oil cooler fittings.
"Just reading vrg3's convoluted, information-packed posts made me feel better all over again." -- subyluvr2212
