EJ22T back together, in the car, now no spark :(

Heads, valves, pistons, rods, crankshaft, etc...

Moderators: Helpinators, Moderators

Post Reply
vrg3
Vikash
Posts: 12517
Joined: Sun Nov 03, 2002 2:13 am
Location: USA, OH, Cleveland (sometimes visiting DC though)
Contact:
Contact vrg3

Post by vrg3 »

I think the wire's supposed to be attached to little clips along the way, so I'm not sure that'll work out right. Unless you just decide not to worry about the clips and break them if necessary.
"Just reading vrg3's convoluted, information-packed posts made me feel better all over again." -- subyluvr2212
Top
Legacy777
Site Admin
Site Admin
Posts: 27932
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:
Contact Legacy777

Post by Legacy777 »

I replaced my crank sensor a while back without removing the intake manifold. You can fish it through with a wire. I'd suggest doing that then trying to canibolize the plug & wiring.
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
Top
Post Reply

Return to “Engine”