91/94 turbo Legacy parts, almost anything you need

gene4ace · Post by **gene4ace** » Mon May 05, 2008 5:14 am

pm sent

bepa · Post by **bepa** » Tue May 06, 2008 6:20 am

frank do you have a 2.2 turbo block I could use. thru a rod. it died a hard death.

as you can see by reading this that tow truck driver guy never was heard from again.

looked at a 2.5 core motor in another pick and pull junkyard. but that is a try and see how it fits, with it live with the turbo (have read that they have used the 2.2 turbo plumbing and all on the 2.5 block. would need an intercooler also. but what a power boost the is!

how to hear from you soon. how all are well on your end. and that you get everyones attention out by you.

P.S. granddaughter is in town for a few months. live is good. be well frank. oh should have my SVZ up and running by wednesday.

be well, bepa

IronMonkeyL255 · Post by **IronMonkeyL255** » Wed May 07, 2008 2:44 am

How about a good stock BPV? I tried putting on my WRX one and ran into insurmountable clearance issues, but also found I needed longer bolts for the flange.......

1991legacyturbo · Post by **1991legacyturbo** » Fri May 09, 2008 7:12 am

do you have any PCV peices, like the one that comes out of the top of the passenger side??

Koot · Post by **Koot** » Mon May 12, 2008 12:48 am

Would you happen to have the full automatic shoulder seatbelt mechanism, wire included for the drivers side? Need it for inspection. If so could you pm me a price shipped to 05156
Thanks

Blackbart · Post by **Blackbart** » Mon May 12, 2008 2:07 am

No stock BPV's at the moment.

I need a better description for the plastic tube.

I have the auto seatbelt setup, PM coming.

91legacyawdturbo · Post by **91legacyawdturbo** » Mon May 12, 2008 6:29 am

About the hood scoop for my 91 could you Pm me a price shipped to 80004

Blackbart · Post by **Blackbart** » Mon May 12, 2008 1:43 pm

91legacyawdturbo wrote:About the hood scoop for my 91 could you Pm me a price shipped to 80004

PM sent.

94SS_Canada · Post by **94SS_Canada** » Mon May 12, 2008 4:32 pm

courtjesterclown · Post by **courtjesterclown** » Mon May 12, 2008 8:52 pm

blackbart, looking for the mechanism ( i think its a pressure sensor) that sits on the inside of the passenger side fender in the engine bay. It has a few vacum lines and one runs to the turbo silencer. This sensor is the one that is directly above the boost control solenoid. Price shipped to 26623.
1994 ej22t automatic.

Carisma · Post by **Carisma** » Sat May 24, 2008 6:12 pm

Do you happen to have a turbo radiator available?

Blackbart · Post by **Blackbart** » Sun May 25, 2008 4:34 pm

courtjesterclown, Looks like Imissed seeing this post, I have the sensor you need, PM coming

Carisma, I have a turbo radiator here, do you need one for an auto (with the tranny coler) or a manual tranny?

Carisma · Post by **Carisma** » Mon May 26, 2008 1:22 am

Blackbart wrote:Carisma, I have a turbo radiator here, do you need one for an auto (with the tranny coler) or a manual tranny?

I need one for a manual transmission.

Is this a stock one (if so, how is the condition)? I need it just to get my swap started and running for a month or two.

Also, do you happen to have a metal coolant tank that will fit a EJ20g?

yazmo · Post by **yazmo** » Fri May 30, 2008 4:41 am

hello here my problem my legacy 94 turbo as a very high gas consumtion like full tank i am doing 280 km

so i wonderibng what could do this
bad ignition timming?
some sensor o2 and coolant temp
what else

dunno if i am capable to read the ecu code

anyone know what are my option:?

yaz109@hotmail.com

Soarer · Post by **Soarer** » Tue Jun 03, 2008 2:53 pm

I'm looking for some rear caliper brackets.

New92 · Post by **New92** » Wed Jun 11, 2008 12:17 am

Hello my favorite parts supplier. I just recently pulled a code 24 so Im looking for a good ACV can you shoot me a price to 30114?
Thanks,
Ben

edit: Sorry, 92 turbo 5spd.

Fkyx · Post by **Fkyx** » Sat Jun 14, 2008 2:46 am

Hi, Frank. Just wondering if you have a set of mudflaps for a '91 SS. If you don't have a complete set, a single left front would do.

97601

Thanks!

BlockerImp · Post by **BlockerImp** » Sat Jun 14, 2008 7:26 am

Looking for a timing belt cover, shipping to 98125

SubaruNation · Post by **SubaruNation** » Sat Jun 14, 2008 8:32 am

Fkyx wrote:Hi, Frank. Just wondering if you have a set of mudflaps for a '91 SS. If you don't have a complete set, a single left front would do.

97601

Thanks!

i'm looking for 4 also

Lurch · Post by **Lurch** » Fri Jun 20, 2008 4:39 am

I need a charcoal colored drivers side lap belt for a 93 SS. My zip is 80112.

Blackbart · Post by **Blackbart** » Fri Jun 20, 2008 3:29 pm

No mud flaps as of now

I don't have the charcoal color seatbelt, only the gray

91legacyawdturbo · Post by **91legacyawdturbo** » Sat Jun 21, 2008 6:47 am

hood scoop payment sent

worunner · Post by **worunner** » Tue Jun 24, 2008 5:34 pm

I need some new front calipers if anyone can swing that.

Blackbart · Post by **Blackbart** » Tue Jun 24, 2008 9:15 pm

I have a few sets of turbo front calipers, PM coming

New92 · Post by **New92** » Tue Jun 24, 2008 9:34 pm

Any luck with that ACV for the code 24?
Thanks.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

91/94 turbo Legacy parts, almost anything you need

block

Seatbelt

Brakes