SS and base model differences?

what huh · Post by **what huh** » Mon May 12, 2008 1:38 am

true true

thanks man

dropdfocus · Post by **dropdfocus** » Mon May 12, 2008 5:02 am

They are splined so they will only line up one way. Easiest thing to consider when putting them back on is if the hole on the shaft has a spline going through it or not.

jefferson · Post by **jefferson** » Tue May 13, 2008 4:23 am

I believe you will find that the hole in the stub and in the axle have a tapered entrance on one side. Both tapered ends go together.

Jeff

what huh · Post by **what huh** » Tue May 13, 2008 9:26 pm

cool thanks for all the help guys

what huh · Post by **what huh** » Thu May 15, 2008 2:51 am

what about brakes?

rotor size?

SP-Boxer · Post by **SP-Boxer** » Thu May 15, 2008 5:25 pm

smh0101 wrote:However, EDM tail lights do Not have any amber in them... So you have to put an amber bulb in.

Correction: ALL EDM taillights have amber inside them. In the 92, you can't see it from the outside, but it's inside!
94 is the same as your 93, with amber!

I'm 100% sure, my 92 EDM car has clear bulbs, no visible amber, and orange signal!

smh0101 · Post by **smh0101** » Fri May 16, 2008 7:37 am

Well, I had 92 EDM Tails and it had no amber, I had to mod them to accept the lights from my front corner lights.

legacy4ever · Post by **legacy4ever** » Fri May 16, 2008 4:15 pm

SP-Boxer is right. smh0101, you've had the tails from me, and I removed the amber inserts long before and drove with amber bulbs in them.

So that's all, sorry for an off-topic "EDM taillights"

smh0101 · Post by **smh0101** » Fri May 16, 2008 5:06 pm

Ahh, that explains it!

Mmkay, didnt know mine where modid... But they were in a very good way. You couldnt see amber at ALL!

what huh · Post by **what huh** » Thu May 22, 2008 11:58 pm

what about the bushing that holds the back of the shift linkage up?

Is that different between the FWD and the AWD?

or did i put something on wrong?

Post by **Legacy777** » Fri May 23, 2008 6:03 pm

what huh wrote:what about the bushing that holds the back of the shift linkage up?

Is that different between the FWD and the AWD?

or did i put something on wrong?

That "should" be the same

what huh · Post by **what huh** » Sat May 24, 2008 2:24 pm

actually they are not when i get my stock one that i just order in (stupid memorial day) i will post a picture. Because it is so much easier to show then tell

Post by **Legacy777** » Thu May 29, 2008 6:16 pm

Yeah you're right. I was lazy before and didn't want to check the parts manual.

what huh · Post by **what huh** » Thu May 29, 2008 7:42 pm

well i got real excited when it came in so i forgot to take a picture. The FWD one sits about 3/4" lower than the AWD which makes it touch the driveshaft.

And for the record also a FWD shift linkage doesn't work.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

SS and base model differences?