An ECU Scan tool for OBD and OBDII Subaru Cars

ripplesouth · Post by **ripplesouth** » Fri May 23, 2008 3:05 am

I received my scan tool today and it works great. If you have an older subaru and you need a professionally built scan tool for under 300au, then point your browser to this australian solution.

theflystyle · Post by **theflystyle** » Fri May 23, 2008 5:33 pm

only if there was a way to view the fuel in a digital format i would jump all over this thing. i hate guessing with our notoriously bad fuel gauges. mine shows about 5 gallons left on e lol.. ive seen my light only when testing the line !!!

Post by **Legacy777** » Fri May 23, 2008 6:03 pm

That looks like a pretty neat scan tool!

ripplesouth · Post by **ripplesouth** » Sat May 24, 2008 6:30 am

the refresh rate on this scanner is very fast compared to the PC solution.

As far as fuel guage, all I do is hit the trip reset after full fillups, and count up 480KM then refill again.

My fuel sensor is due for r/r

ripplesouth · Post by **ripplesouth** » Sat May 24, 2008 6:33 am

I've now been able to see the knock, O2, digital temperature, maf.

I've noticed my O2 readouts are bouncing. My car has rough idle and hesitation. How would I track down the source?

Also I noticed that my timing advance is only 20degrees. This could be bad for fuel efficiency.

Post by **Legacy777** » Thu May 29, 2008 5:52 pm

O2 readout should be bouncing between 0 and 1 volt.

When you're reading the timing advance, is the 20 deg during normal cruise, acceleration, decel, idle, etc??

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

An ECU Scan tool for OBD and OBDII Subaru Cars

An ECU Scan tool for OBD and OBDII Subaru Cars