FS in Canada: 5 speed Tranny

94SS_Canada · Post by **94SS_Canada** » Fri Jul 25, 2008 6:39 am

5 speed, Hydraulic actuacted transmission, in Great shape, just over 80,000km, Includes Clutch Fork and throw out bearing, It is out of a 1998 subaru RS.

The Tranny is Best offer, i back all my sales and offer full/ partial refunds on whatever i sell, I HOWEVER dont offer refunds for a transmission that was broken from being abused or you bought the wrong tranny for your car.

This will fit our legacys.

The tranny is in Good Shape, No lowballers!

LOCATED JUST SOUTH OF CALGARY, AB

Can arrange for drop off/ pick-up

Pm me here or email me at running_from_thelaw@hotmail.com

What you see is what you get (minus the cardboard, spraypaint, you get what i mean)

smh0101 · Post by **smh0101** » Fri Jul 25, 2008 7:09 am

Thats a cable clutch tranny... not hydraulic...

94SS_Canada · Post by **94SS_Canada** » Fri Jul 25, 2008 7:11 am

The Tranny is hydraulic, it clearly shows that in the pics

smh0101 · Post by **smh0101** » Fri Jul 25, 2008 7:12 am

I didnt know they made hydraulic push type clutches.... Because thats a pusher, not a puller.

smh0101 · Post by **smh0101** » Fri Jul 25, 2008 7:16 am

So basically its a different setup than our Legacys.

86ruguy · Post by **86ruguy** » Fri Jul 25, 2008 1:53 pm

UM, the cable tranny's were pull type. it's kinda hard to make a pull type hydraulic set-up

94SS_Canada · Post by **94SS_Canada** » Fri Jul 25, 2008 5:36 pm

Wow i feel like an idiot sorry, WRONG TRANY IM TALKING ABOUT!

It wont fit or legacyies, it is a cable, operated tranny

Matt Monson · Post by **Matt Monson** » Fri Jul 25, 2008 7:07 pm

That tranny will fit an NA legacy. It would need to be converted to a cable clutch (just take the TO fork from the Legacy tranny) or the Legacy would need to be converted to hydraulic (bit more complicated involving lines and master cylinder).

It will NOT work with a factory turbo Legacy because those are pull type trannies. Unless, you were to change to a push type clutch and pressure plate, and remove the stock slave cylinder and instead hook up the one that is on the tranny for sale.

There are many ways to make these things work. Just remember that it's a 4.11 and the car it's going into needs to also be a 4.11 or be converted over to a 4.11 rear end. Good luck with your sale.

94SS_Canada · Post by **94SS_Canada** » Sat Jul 26, 2008 6:28 am

Thanks, i think im better off over at RS25 with this one.

douglas vincent · Post by **douglas vincent** » Sat Jul 26, 2008 6:47 am

Is there a hydralic acutated sltye cable existing?

smh0101 · Post by **smh0101** » Sat Jul 26, 2008 6:50 am

Thats kinda what it looks like??

I'm lost.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

FS in Canada: 5 speed Tranny

FS in Canada: 5 speed Tranny