I need to buy a factory Subaru heat exchanger for the AWIC setup...the one I have now requires me to cut my bumper and I don't want to do that. Any help would be appreciated.
Thanks
-Andrew
drewriviera@yahoo.com
WTB: AWIC Heat Exchanger
Moderators: Helpinators2, Moderators
Forum rules
Please see the NEW Parts Shed Rules before posting: http://www.bbs.legacycentral.org/viewto ... 15&t=55814
Sales of parts and parting cars only. Complete or parted car posts should be made in Car Lot: http://www.bbs.legacycentral.org/viewforum.php?f=32
Please see the NEW Parts Shed Rules before posting: http://www.bbs.legacycentral.org/viewto ... 15&t=55814
Sales of parts and parting cars only. Complete or parted car posts should be made in Car Lot: http://www.bbs.legacycentral.org/viewforum.php?f=32
-
drewriviera
- First Gear
- Posts: 196
- Joined: Wed Jun 20, 2007 9:38 pm
- Location: Asheville, NC
-
farfrumwork
- Second Gear
- Posts: 334
- Joined: Thu Jan 08, 2004 1:04 am
- Location: mile high
Sorry, I don't have what you're looking for but have you looked into the Mustang Cobra stock heat exchangers?
They are long and fairly narrow. I was looking into some of the aftermarket cobra units, and by the measurements I found I think the stock exchanger would fit in the lower section of the SS bumper. They are fairly cheap too.
I am not sure what brand exchangers i have for my AWIC setup, but they are 1" deep so they fit behind the bumper beam. I run 2 in series, and they are about 10"x8" (or so, I can't remember off the top of my head). Mine are appear to be very nice, with a ton of fins per inch (technical description I know
) - Again, I haven't been able to determine what they are though....
Good luck!
They are long and fairly narrow. I was looking into some of the aftermarket cobra units, and by the measurements I found I think the stock exchanger would fit in the lower section of the SS bumper. They are fairly cheap too.
I am not sure what brand exchangers i have for my AWIC setup, but they are 1" deep so they fit behind the bumper beam. I run 2 in series, and they are about 10"x8" (or so, I can't remember off the top of my head). Mine are appear to be very nice, with a ton of fins per inch (technical description I know
) - Again, I haven't been able to determine what they are though....Good luck!
Old - '93 T-Leg - 14.693 @ 92.68 at 5800ft ASL (Bandimere Speedway)
New - 07 Spec B/stg 2
"bloodstains - speed kills -fast cars - cheap thrills -rich girls - fine wine
i've lost my sense - i've lost control - i've lost my mind" Agent Orange
New - 07 Spec B/stg 2
"bloodstains - speed kills -fast cars - cheap thrills -rich girls - fine wine
i've lost my sense - i've lost control - i've lost my mind" Agent Orange