Need to find a parts diagram website

Where the power meets the road.

Moderators: Helpinators, Moderators

Post Reply
dropdfocus
Fourth Gear
Posts: 1937
Joined: Sun Sep 07, 2003 5:57 am
Location: Williamsport, PA
Contact:

Need to find a parts diagram website

Post by dropdfocus »

I picked up WRX brake calipers w/ H6 brackets & rotors, but I don't have the rubber boots or the pieces that hold them in place. I believe the 2 bolts are used as sliders, but I want to double check that. Is there a site that has an exploded parts diagram that I can check this out? I did a general seach on Google, but didn't turn up anything worth while.

Thanks in advance to anyone who can supply info for me!!
Jason
'92 LSS "Trixie" - TD04, '06 WRX TMIC, Invidia D/P & TXS U/P, 3" APEX'i CBE, custom intake, TXS MBC & BPV
Perrin LCP, WRX & H6 brakes, S/S lines, Cusco H-brace & RSTB, AGX's, Progress springs, SimplySubie fender braces
n2x4
Fourth Gear
Posts: 1522
Joined: Tue Oct 18, 2005 3:52 pm
Location: Massillon, Ohio

Post by n2x4 »

Rear right? Let me see what I can find..
SUBARUEHS Racing
dropdfocus
Fourth Gear
Posts: 1937
Joined: Sun Sep 07, 2003 5:57 am
Location: Williamsport, PA
Contact:

Post by dropdfocus »

Yeah, rear. I have WRX fronts w/ PowerSlot rotors & Goodridge lines all around. This is the last bit of stuff I need to get the car off the jack stands & on the ground again (it's been in the air for almost 2 months getting fully overhauled).
Jason
'92 LSS "Trixie" - TD04, '06 WRX TMIC, Invidia D/P & TXS U/P, 3" APEX'i CBE, custom intake, TXS MBC & BPV
Perrin LCP, WRX & H6 brakes, S/S lines, Cusco H-brace & RSTB, AGX's, Progress springs, SimplySubie fender braces
n2x4
Fourth Gear
Posts: 1522
Joined: Tue Oct 18, 2005 3:52 pm
Location: Massillon, Ohio

Post by n2x4 »

WRX rear brake assembly:
Image
Image

Looks like there's not a separate part number for the caliper slider bolts. Hope those pics have what you needed!
SUBARUEHS Racing
dropdfocus
Fourth Gear
Posts: 1937
Joined: Sun Sep 07, 2003 5:57 am
Location: Williamsport, PA
Contact:

Post by dropdfocus »

Ok, the rubber booting & boot attachment hardware are what I'm lacking. The fella I got the stuff from informed me today that he believes he found what I'm looking for at his place, but I still wanted to know what all it is I'll need to make it complete in the rear via the diagram.

Thanks a ton for posting that up! Did you scan that in from something you have on hand or is that sourced from some where online?
Jason
'92 LSS "Trixie" - TD04, '06 WRX TMIC, Invidia D/P & TXS U/P, 3" APEX'i CBE, custom intake, TXS MBC & BPV
Perrin LCP, WRX & H6 brakes, S/S lines, Cusco H-brace & RSTB, AGX's, Progress springs, SimplySubie fender braces
Post Reply