Door chime?

uberoo · Post by **uberoo** » Sat Jun 20, 2009 11:46 pm

I tried searching, but I didnt really find anything. I want to remove the door chime, because it is very annoying but I would still like my roof light to light up when the door is open.What does the door chime thing look like where is it at?I tried looking under the dash but I wasnt able to pinpoint its location.Thanks in advance.

Lego · Post by **Lego** » Sun Jun 21, 2009 3:58 am

the chime is inside the gauge cluster, though i dont know how to disable it. i agree its extremely annoying

uberoo · Post by **uberoo** » Sun Jun 21, 2009 5:54 am

Skruyd · Post by **Skruyd** » Sun Jun 21, 2009 7:21 am

Are you talking about the Key warning chime???? It look like it's in the Combination meter like Lego said but it runs through the Automatic seat belt control unit. Try unplugging the big plug on the control unit and see if that stops the dinger. If so, the books shows it is terminal 4 on that plug that powers the dinger. If you need the schematic I can always post a pic if you can't find one.

uberoo · Post by **uberoo** » Sun Jun 21, 2009 9:04 am

what does the control unit look like and where is it?

magicmike · Post by **magicmike** » Sun Jun 21, 2009 5:16 pm

you can just unplug the switch at the key cylinder. Its a black 2 pos plug if i'm not mistaken. Its located along the rest of the wires coming off of the key switch right where your right knee would bee when you take the dash panel off. It will be very thin wires like 22 awg ish.

Skruyd · Post by **Skruyd** » Sun Jun 21, 2009 5:18 pm

uberoo wrote:what does the control unit look like and where is it?

In the trunk on the left hand side "driver side". It should be near the power antenna. Has two plugs in it.

magicmike · Post by **magicmike** » Sun Jun 21, 2009 5:56 pm

Skruyd wrote:
uberoo wrote:what does the control unit look like and where is it?
In the trunk on the left hand side "driver side". It should be near the power antenna. Has two plugs in it.

Why on earth would you unplug the whole control unit when you can do what I said in one post above this one?

uberoo · Post by **uberoo** » Mon Jun 22, 2009 5:49 am

I will try the ignition switch first then check out the computer if it doesnt take care of the chime..

kimokalihi · Post by **kimokalihi** » Mon Jun 22, 2009 2:36 pm

I hated that noise too. I took my gauge cluster out and found out where that noise was coming from. Then I filled the little hole with liquid nails thinking it would kill the noise. It didn't. Made it not so loud but still quite audible. I just left it alone after that though.

magicmike · Post by **magicmike** » Mon Jun 22, 2009 4:05 pm

uberoo wrote:I will try the ignition switch first then check out the computer if it doesnt take care of the chime..

I'm not guessing here folks. I unplug the stupid thing when I'm working on the car and need the key on and the door open.

gijonas · Post by **gijonas** » Mon Jun 22, 2009 4:49 pm

^^^ he is right it works and takes like 5 seconds to do.

amdrunner · Post by **amdrunner** » Tue Jun 23, 2009 3:54 am

What about the wagon? Is the module in the back as well?

vrg3 · Post by **vrg3** » Tue Jun 23, 2009 7:49 pm

Mike - I do the same thing, but if I forget to reconnect it the seatbelt control unit gets mad. I don't know if it's a long-term solution.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

Door chime?

Door chime?