Does anyone know the size of the female threads on the power steering pump? I've looked through FSM's and couldn't find it, I need to figure this out so I can finish my stainless steel braided connections to the pump.
FYI: The WRX PS Pump is a 14mmx1.5mm threaded w/ o-ring. it's smaller than our connections which I think is a 16mmx1.5mm; but I'm not sure
Any help would be appreciated.
PS Pump pressure thread size
Moderators: Helpinators, Moderators
PS Pump pressure thread size
91 Legacy Wagon, Total Rally Car.
#82 M4 TRSCCA Rallycross
http://www.youtube.com/mobilepolice/
#82 M4 TRSCCA Rallycross
http://www.youtube.com/mobilepolice/
-
SLODRIVE
- Third Gear
- Posts: 662
- Joined: Fri Nov 21, 2008 1:27 am
- Location: Colorado, north of Highway 52
- Contact:
It is indeed an M16 x 1.5 o-ring fitting.
Speedway Motors has AN adapters for them; I was looking into the same thing before I finally managed to bend the OEM line to fit.
Speedway Motors has AN adapters for them; I was looking into the same thing before I finally managed to bend the OEM line to fit.
http://www.slodriveracing.com
-92 SS 5MT- EJ20H swap, Haltech standalone ECU, TD04, FXT TMIC, 3" exhaust, STi/AGX struts, JDM 5-speed, 4.111 LSD rear, Blitz EBC, etc.
-'93 L Wagon - Pink Roll Cage - "Dirty Leg"
-And more!
-92 SS 5MT- EJ20H swap, Haltech standalone ECU, TD04, FXT TMIC, 3" exhaust, STi/AGX struts, JDM 5-speed, 4.111 LSD rear, Blitz EBC, etc.
-'93 L Wagon - Pink Roll Cage - "Dirty Leg"
-And more!