Old scoop design... *meh.. sorta cool, but not great*
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/5676931484_ORIG.jpg)
And..
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/5717800895_ORIG.jpg)
New scoop design...
I figured I'd keep a pic of the latest work here at the intro to grab people's attention...
Front View In Primer:
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/PICT0242.jpg)
Before Final Fitment..
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/PICT0250.jpg)
After Final Fitment... *ready for last layer of paint, pardon the glossy bits, I've not fully scuffed the first layer*
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/PICT0324.jpg)
Ohh.. Ahhh.. NEAR-OEM fitment kicks ass! It's so close I figure, if anyone wanted it to fit any tighter, it'll have to be done by a professional body guy.
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/PICT0322.jpg)
See, this is as good as it gets with my hands *it'll be shinier though, as this is one last layer and a buffing from being completely finished...
![Image](http://i96.photobucket.com/albums/l180/yasafusa/Scoop/PICT0325.jpg)
I know, last year I nearly completed the original design and had a few, "this is just a wind up" comments, so neener neener... I've been honing my mold making and fiberglass skills... And got to a point where my original design was too... "blocky" and JUST function... So I started over, redrawing and reshaping... Now I believe I've got a much better shape *follows the body style AND it provides the same cooling ability with even less turbulance...
I can produce these as a BOLT on, ready to paint *with minimal finishing* that these parts are so much closer to "show" than "race quality" that people usually grade their fiberglass parts.
These CAN be made available in carbon fiber too for the additional cost of the carbon *methods are still the same as the fiberglass in laying up...
Here's the purchase thread:
http://bbs.legacycentral.org/viewtopic. ... highlight=