ok there was a bunch of talk about doing this without doing the face-lift swap, but i have everything i need to do a face-lift on my 91 except the fenders, and my main question is to wire up the blinkers to the corner markers do i need to find a 2 filament bulb that will work and find a new plug with 3 wires and just extend the signal wire from the pre face-lift blinks to make this work?
thanks
eric
wireing face-lift corner lights to blink on pre facelift car
Moderators: Helpinators, Moderators
-
- In Neutral
- Posts: 42
- Joined: Fri Aug 14, 2009 7:22 pm
- Location: Farmington Maine
- Contact:
wireing face-lift corner lights to blink on pre facelift car
Co Founder of MaineSubies.com
91 SS, in need of some major TLC (work in progress)
Im lost in Maine, but ill find my way out eventually
91 SS, in need of some major TLC (work in progress)
Im lost in Maine, but ill find my way out eventually
The connector will likely be different, but you should be able to find one and just splice it into your pre face harness.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
-
- In Neutral
- Posts: 42
- Joined: Fri Aug 14, 2009 7:22 pm
- Location: Farmington Maine
- Contact:
-
- In Neutral
- Posts: 42
- Joined: Fri Aug 14, 2009 7:22 pm
- Location: Farmington Maine
- Contact:
All you need is the bulb and harness from a 92-94. You can test the wires on a battery to see which filament is the blinker (brighter one) and which is the corner light.
You have to cut the connectors off the blinker and the corner lights.
After that you splice the grounds together on your pre-facelift car, and route the power from the bumper blinker to the new bulb harness.
I did this on my 91 without the face lift by cutting the bulb receptacle off the 92 corner lights and plastic weld them to my 91 corner lights.
You have to cut the connectors off the blinker and the corner lights.
After that you splice the grounds together on your pre-facelift car, and route the power from the bumper blinker to the new bulb harness.
I did this on my 91 without the face lift by cutting the bulb receptacle off the 92 corner lights and plastic weld them to my 91 corner lights.
maciek puszynski
01 Impreza | v6 STi RA | 5mt | ej236t
93 Legacy Turbo | TW | 4eat | ej22t
16 WRX | 6mt | fa20
98 Legacy GT | wagon | 5mt | ej25d
2.36L Turbo - RSTi Build
01 Impreza | v6 STi RA | 5mt | ej236t
93 Legacy Turbo | TW | 4eat | ej22t
16 WRX | 6mt | fa20
98 Legacy GT | wagon | 5mt | ej25d
2.36L Turbo - RSTi Build