I'm just about ready to start working on swapping everything from my wagon to my SS and so im going to put this up for sale seeing as i don't drive my wagon right now anyways (Bad transmission)
So this is i guess a transmission fund raiser....
Anyways it's fron a 95-99 Legacy wagon. i use 4 self tapping screws to hold it down in 4 countersink holes. and also used bondo to fill the crack on top. It's not hard to put on at all. on my car i decided to remove the top rear window trim and cut down the 2 side pieces. It's still on my wagon but i will remove it when someone pays. paypal accepted... i will ship if necessary.
anyways im looking for 50 bucks OBO. If you want to buy local call CJ @ 253 820 2698
91 L-TW Wagon with a full Swap -RIP
92 SS Prefaced, GD dash swapped, 22T/205 Hybrid 20 psi - BEAST!
93 SS Bone Stock Gone!
94 TW Bone Stock Gone!
91 SS 4EAT Sold!
98 LGT 4EAT
98 LGT Wagon 4EAT
yes the middle spot does interfere with the wiper. but I think the middle spot can be ground down. Easier way to take care of that problem is just to buy a smaller wiper blade.
91 L-TW Wagon with a full Swap -RIP
92 SS Prefaced, GD dash swapped, 22T/205 Hybrid 20 psi - BEAST!
93 SS Bone Stock Gone!
94 TW Bone Stock Gone!
91 SS 4EAT Sold!
98 LGT 4EAT
98 LGT Wagon 4EAT
ah, well im definitly would want to buy it..it would be going on a raised roof hatch so by the looks of it there will be no need to cut the trim or shorten the wiper
here's some more pictures of it Un-Installed. I used some self tapping screws similar to drywall screws i'll send those if you really want them but they're pretty cheap at lowes or home depot.
91 L-TW Wagon with a full Swap -RIP
92 SS Prefaced, GD dash swapped, 22T/205 Hybrid 20 psi - BEAST!
93 SS Bone Stock Gone!
94 TW Bone Stock Gone!
91 SS 4EAT Sold!
98 LGT 4EAT
98 LGT Wagon 4EAT