1994 Legacy Early EJ22, not wanting to start will crank over. got under the dash the green connectors on the left of the steering column were plugged in and the black connectors on the right hand side were plugged in too. I tried to connect the green and black connectors to get the Codes but the CEL just blinks and won't do anything but that if i plug them both in again the CEL just stays on. WHAT THE HELL.. IDK what im doing i guess..
Please any help would be good
Trying to check codes but the CEL just blinks
Moderators: Helpinators, Moderators
-
ScoobyLegacy
- In Neutral
- Posts: 11
- Joined: Tue Nov 16, 2010 5:55 am
Re: Trying to check codes but the CEL just blinks
Does it blink constantly or different patterns? http://legacycentral.org/library/literature/codes.htm
'11 WRX Limited
'94 SS | 3" TBE, 07 TMIC, TD05H-16G, Revtronix Stage 2, Walbro -- Sold
'94 TW | R.I.P.
Re: Trying to check codes but the CEL just blinks
Welcome to the BBS. Only the black connectors should be plugged in to check the codes. Also, the black & green connectors should normally be unplugged.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm