removing 5mt from engine

Falken-18c · Post by **Falken-18c** » Thu Jul 21, 2011 2:01 am

ok so when i seperated my 5mt from my motor i just noticed when i used the crow bar it skared up and put lil nudges on the side of the tranny where it seals to the engine in think its not bad and it should seal up but is there and sealnt i could put on it to make sure it seals good ill probly take pics on the week end if im at my car

Post by **Legacy777** » Thu Jul 21, 2011 2:04 am

You'll be fine. The surfaces don't really do any sealing.

Falken-18c · Post by **Falken-18c** » Thu Jul 21, 2011 2:09 am

ok kool... im always thankfull for the advise

Florin1 · Post by **Florin1** » Thu Jul 21, 2011 8:31 am

Haha, yeah. no sealing needed. If you peak underneath your car you can actually see your clutch. There's a big 2"x6" slot. That would be a lot of filler. lol

Falken-18c · Post by **Falken-18c** » Thu Jul 21, 2011 11:26 pm

lol kool thanks

cj91legss · Post by **cj91legss** » Fri Jul 22, 2011 12:57 pm

Florin1 wrote:Haha, yeah. no sealing needed. If you peak underneath your car you can actually see your clutch. There's a big 2"x6" slot. That would be a lot of filler. lol

might have to go to home depot and buy a box of dark grey caulking or get some color matched!!!

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

removing 5mt from engine

removing 5mt from engine

Re: removing 5mt from engine

Re: removing 5mt from engine

Re: removing 5mt from engine

Re: removing 5mt from engine

Re: removing 5mt from engine