how to remove this pin

Falken-18c · Post by **Falken-18c** » Sat Sep 17, 2011 4:14 pm

idk how to remove this pin if some one could help me that be great http://s1213.photobucket.com/albums/cc4 ... 0_0589.jpg

Deride · Post by **Deride** » Sat Sep 17, 2011 4:41 pm

You don't want to take that little pin out. Take the 10mm allen cover off the side of the tranny and thread a bolt into the dowel pin and pull it out.

Falken-18c · Post by **Falken-18c** » Sat Sep 17, 2011 4:46 pm

so the hex on the driver side

Falken-18c · Post by **Falken-18c** » Sat Sep 17, 2011 4:48 pm

so a 10 mm bolt thread in

Deride · Post by **Deride** » Sat Sep 17, 2011 4:58 pm

Its a 10mm allen(hex) for the cover. Once you have that off you will see a threaded hole find a random subaru bolt that will fit in it, put it in a few threads then pull the bolt backwards and the pin should come out.

Falken-18c · Post by **Falken-18c** » Sat Sep 17, 2011 5:04 pm

ok thanks

Florin1 · Post by **Florin1** » Sat Sep 17, 2011 10:52 pm

I had a heck of a time breaking that hex bolt loose! It finally worked once i took a torch to the trans case, and put a big breaker bar on the bolt. I was crossing my fingers on not stripping it.

kimokalihi · Post by **kimokalihi** » Sat Sep 17, 2011 11:06 pm

Make sure to grease it up or hit it with some anti seize before putting it back in to prevent corrosion.

Deride · Post by **Deride** » Sat Sep 17, 2011 11:21 pm

Yea I've broken a few sockets on them, its wise to use heat first instead of a last option on old stuff. Mini propane torches are your friend.

Falken-18c · Post by **Falken-18c** » Sun Sep 18, 2011 10:25 pm

lmao i got lucky i guess i used a 10mm allen key and just hit it in good with a hammer came out with a little mussle i tend to hammer even a scew driver on screws because ive stiped alot of heads off them but after some one told me to hammer it on first never had a problem and the allen key was only about 6-7" one hand and it came out can you say lucky

super_usdm · Post by **super_usdm** » Wed Sep 21, 2011 10:48 pm

Did the pin come right out? I had a hell of a time getting mine out. I had to use a full sized pry-bar like burglers use to pull it.

Falken-18c · Post by **Falken-18c** » Thu Sep 22, 2011 12:50 am

yea it also came easy.. probly because it had a clutch replaced 2009 it was good but i killed the clutch going sideways on dry pavement clutch didnt grab at times did it twice wouldnt grab ate the disk up good lmao so ill just stick to gravel dirt MAYBE WET PAVEMENT but next time i buy a clutch ima shop around i paid 600$ with a friend discount was gunna be close are over 900$ just an exedy clutch probly not worth it

biggreen96 · Post by **biggreen96** » Mon Oct 03, 2011 4:54 am

Do Canadian keyboards have this key?

Falken-18c · Post by **Falken-18c** » Mon Oct 03, 2011 6:03 am

no i removed mine lol

Falken-18c · Post by **Falken-18c** » Mon Oct 03, 2011 6:06 am

also i type this all on my ps3. Im never on the computer. Also my playstation is faster lol.

kimokalihi · Post by **kimokalihi** » Mon Oct 03, 2011 12:56 pm

Not on a controller I hope...I can't handle typing on a controller. And if my pc were slower than my PS3 I would shoot myself in the face.

Deride · Post by **Deride** » Mon Oct 03, 2011 2:25 pm

Haha a week ago my phone was faster than my computer. I fixed that problem though.

Falken-18c · Post by **Falken-18c** » Mon Oct 03, 2011 8:49 pm

lol yea i type on the controller

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

how to remove this pin

how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin

Re: how to remove this pin