02 WRX 20mm front swaybar
Moderators: Helpinators, Moderators
-
Thesubielover
- Third Gear
- Posts: 709
- Joined: Tue Feb 14, 2012 11:20 am
- Location: Seattle, WA
02 WRX 20mm front swaybar
I'm aware that these fit a 93ss, but I was wondering if I can use my stock endlinks or which ones I should go with since they may need to be replaced any ways.
93ss 3inch tbe, Hallman mbc,06 wrx td04, tmic, bov, bugeye seatsStolen x2, sold
93ss Stroker,440cc inj, VF39, '06 TMIC, EJ20G heads & intake, EJ25 crank, 4.11Traded
93ss 4eat, coils, stanced, wraped, flat black, stock show car
93ss Stroker,440cc inj, VF39, '06 TMIC, EJ20G heads & intake, EJ25 crank, 4.11Traded
93ss 4eat, coils, stanced, wraped, flat black, stock show car
Re: 02 WRX 20mm front swaybar
You should be able to use the stock end links. If anything you may just need to make the hole on the anti-sway bar a little bigger if needed.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
Re: 02 WRX 20mm front swaybar
the wrx sedan bar is wider. You want a wrx wagon specific bar.
the difference in the endlinks is the lower hole where it mounts to the control arm. narrow/wagon arms are different from WRX sedan arms. The WRX swaybar will attach to stock endlinks just fine. WRX endlinks will not attach to the stock control arms very well.
the difference in the endlinks is the lower hole where it mounts to the control arm. narrow/wagon arms are different from WRX sedan arms. The WRX swaybar will attach to stock endlinks just fine. WRX endlinks will not attach to the stock control arms very well.