1993 legacy ss need help please look!

Heads, valves, pistons, rods, crankshaft, etc...

Moderators: Helpinators, Moderators

Post Reply
turbolegacy93
In Neutral
Posts: 13
Joined: Sun Jul 29, 2012 9:30 am

1993 legacy ss need help please look!

Post by turbolegacy93 »

Alright so in July I lost 1st gear and drive it without it fir awhile then I parked ad occasionally started it. It sat till September and I drove it to the mechanics to get a tranny put in. It ended up being the wrong one. Then it sat for about 2 months with no tranny in it or inter cooler on it. We too it out and got a tranny put in it yesterday and when we start it the idle stumbles a bit. When you drive it and get to like 2500-3500 rpm it looses all power and stumbles really bad then try to shut off an the check engine light flickers on and off and puffs a little black smoke. Please help we do not know what it is!!!
Legacy777
Site Admin
Site Admin
Posts: 27902
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Re: 1993 legacy ss need help please look!

Post by Legacy777 »

I would highly recommend you check the ECU for codes. The check engine light came on and left a code, this will help you narrow down what the problem is.

You can read the instructions on how to pull the codes from my site

www.surrealmirage.com/subaru/engine.html
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
Post Reply