One piece driveshaft

03bug · Post by **03bug** » Sun Jul 21, 2013 10:29 pm

Is anyone running a custom one piece driveshaft? I am thinking about going this rout if I can't find a used replacement within a couple days. I am trying to get my car ready for the big nw meet and I need a driveshaft. Also can I pull apart the 2 piece driveshaft on my 91ss? I need to replace the rear section due to a bad u joint but I can't find a 5mt shaft.

Post by **Legacy777** » Mon Jul 22, 2013 3:01 am

The rear section of all the 91-94 legacy driveshafts are the same. The front section on the 2-piece units are the only thing that is different. As long as you find a rear section from a 2-piece 90-94 Legacy (turbo, non-turbo, MT, or AT) it'll work.

rallyak · Post by **rallyak** » Mon Jul 22, 2013 6:21 am

I replaced the rear u joint on mine. They do make replacements but are hard to get the parts guy to find them. I can dig in my pile of receipts an find a part# if you need it.

rallyak · Post by **rallyak** » Mon Jul 22, 2013 6:36 am

Found the # 430-10

03bug · Post by **03bug** » Thu Jul 25, 2013 2:19 am

Thanks guys I was able to find a used drive shaft. I will have to write they part number down for future reference.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

One piece driveshaft

One piece driveshaft

Re: One piece driveshaft

Re: One piece driveshaft

Re: One piece driveshaft

Re: One piece driveshaft