Valve Cover Breathers
Moderators: Helpinators, Moderators
Valve Cover Breathers
I am going to start modding on my new Legacy SS, and my first plan was to get rid of my dilapidated intake track. I want to just build a custom intake using off the shelf stuff that I can modify to get the fitment right. I noticed on the intake there was two PCV (I am assuming there purpose) lines the run from the top of each valve cover into the pre-turbo intake. My question is would it be ok to remove them and just add a little breather filter like on old hot rods? This would simplify my intake greatly and save lots of space under the hood!
1994 Legacy SS 4.11 4EAT (Other mods planned)
De-Snorkled and K&N Air Filter
2013 Honda CR-Z 6 Speed Hyrbid
De-Snorkled and K&N Air Filter
2013 Honda CR-Z 6 Speed Hyrbid
Re: Valve Cover Breathers
I would not recommend it.
Check out this thread for more PCV system info.
http://bbs.legacycentral.org/viewtopic.php?f=5&t=50906
Check out this thread for more PCV system info.
http://bbs.legacycentral.org/viewtopic.php?f=5&t=50906
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm