TCU code 14 Shift solenoid 2

Flywheel, Clutch, Transmission, Axles, etc...

Moderators: Helpinators, Moderators

Post Reply
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

TCU code 14 Shift solenoid 2

Post by turbo970 »

if this is faulty would it cause random limp modes? i can drive the car a few days and then while driving it goes to limp mode. i pull over put it in park turn the car off then on and it drives fine til it happens again. only code in the tcu is 14. i'm hoping its under warranty do to they are supposed to be new since i had the trans rebuilt.
Legacy777
Site Admin
Site Admin
Posts: 27890
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Re: TCU code 14 Shift solenoid 2

Post by Legacy777 »

I would maybe suspect there's a loose wire that may be causing that code to come up. If it's a new trans I'd definitely go back and push them for warranty work.
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
turbo970
Third Gear
Posts: 859
Joined: Sun Jul 15, 2012 11:50 pm
Location: sw colorado

Re: TCU code 14 Shift solenoid 2

Post by turbo970 »

its goin wed the shop that put it in want to do a 3000 mile check up on it. i told him what its doing and he thought the same think
Post Reply