Pulled the code from ECU.
33
Error Codes:33, 24 and a weird fail-safe operation
Moderators: Helpinators, Moderators
-
93LegacyTurbo
- In Neutral
- Posts: 13
- Joined: Tue Oct 15, 2002 4:19 pm
Error Codes:33, 24 and a weird fail-safe operation
Last edited by 93LegacyTurbo on Wed May 25, 2005 11:01 pm, edited 2 times in total.
-
vrg3
- Vikash
- Posts: 12517
- Joined: Sun Nov 03, 2002 2:13 am
- Location: USA, OH, Cleveland (sometimes visiting DC though)
- Contact:
When the car's moving fast, the ECU normally turns the radiator fans off, since there's enough air passing by the radiator anyway. I suspect that part of the code 33 failsafe condition is that it continuously runs the fans.
When the CEL came on this second time after resetting, was it still both codes 33 and 24?
When the CEL came on this second time after resetting, was it still both codes 33 and 24?
"Just reading vrg3's convoluted, information-packed posts made me feel better all over again." -- subyluvr2212
radiator fans are on because of error code 33. When my speedo sensor went out, that's what happen with mine too. If I reset the ECU...it'd be fine for a little bit, as I drove around, it had the problems.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm