I waited till being far enought to give you a little update
![Smile :)](./images/smilies/icon_smile.gif)
So this his how it goes..
All gaps were checked with Plastiguage.. amaisingly, i'm into the stock specs even without any crankshaft rework.
![Image](http://images6.fotki.com/v94/photos/1/17179/1140861/1666699_img-vi.jpg)
shortblock closed after a lot of problems finding guide-pins
![Wink ;)](./images/smilies/icon_wink.gif)
all bolts torqued to specs, with some engine oil on the threads.
![Image](http://images6.fotki.com/v94/photos/1/17179/1140861/1676711_img-vi.jpg)
Pistons, pins and lock pins installed.. ahhh relief ! hehe
![Image](http://images6.fotki.com/v94/photos/1/17179/1140861/1676715_img-vi.jpg)
![Image](http://images6.fotki.com/v94/photos/1/17179/1140861/1676717_img-1-vi.jpg)
![Image](http://images6.fotki.com/v92/photos/1/17179/1140861/1676720_img-vi.jpg)
and the finaly assembled shortblock. Looks not pretty good especially with that rusted water-pump wheel, but in real it looks nice.. pics is bad :\ hehe i'll have to sand a little bit that wheel so rust goes away ... (that's the only pump with oil-cooler nipple i have :\ )
![Image](http://images6.fotki.com/v95/photos/1/17179/1140861/1676718_img-vi.jpg)
If i receive the guide-pins for the heads tomorrow, i'll then install the heads, water passage, maybe oil-pan too. I'll keep you updated.
All other pics, and hirez are at this url :
http://public.fotki.com/morgie/morgie/o ... age_moteur