Pics of the piping

dzx · Post by **dzx** » Mon Nov 22, 2004 9:13 pm

Let me know if the link doesnt work.

It's dirty, It's messy, It gets the job done. I need to clean up my engine bay a little more. The sun was in a bad position where i parked but i'll take some better pics later let me know if there is a specific spot you want to see.

http://www.cardomain.com/memberpage/641778/6

Oh yeh, ignore the duct tape on the coffee cup

legacy92ej22t · Post by **legacy92ej22t** » Mon Nov 22, 2004 9:30 pm

Looks good! I wanna see a front end shot though too.

azn2nr · Post by **azn2nr** » Tue Nov 23, 2004 4:24 am

and one of the passanger side where the pipe goes down into the front. and passanger side in general.

whats your pipe size and is it crush or mandrel or a combination of both.

jake15 · Post by **jake15** » Tue Nov 23, 2004 4:33 am

looks good, where did you get the silicone couplers and how much? where'd you get the pipes? did you do any welding? thats all the ?? i can think of for now....

dzx · Post by **dzx** » Tue Nov 23, 2004 5:35 am

The silicone i got from an RV/Truck store. It was 20 dollars a foot. The piping is 2.5" and is mandrel bent, all of it. The pipes i bought off of ebay aluminum bends were 20 dollars each, 5 foot section of stainless steel was 33 dollars but shipping was expensive and i never did get the other 5 foot section i ordered. I didn't do any welding because i dont have a welder for aluminum or stainless steel and the couplers hold it just fine. I'll take those pics sometime tomorrow.

ultrasonic · Post by **ultrasonic** » Tue Nov 23, 2004 6:22 am

all work and no play make jack a dull boy.

Props to Jack and Stanley.

dzx · Post by **dzx** » Wed Nov 24, 2004 12:39 am

pics are up

azn2nr · Post by **azn2nr** » Wed Nov 24, 2004 5:27 am

deng you have the small abs

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

Pics of the piping

Pics of the piping