Re: What did you do to your Subie today?
Posted: Sun Sep 15, 2013 9:36 pm
Those just look like part of the grill and are kind of like "eye lid" type things for the head lights.
legacycentral bbs
A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans
https://bbs.legacycentral.org/
What did you do to your Subie today?
Page 92 of 131
Re: What did you do to your Subie today?
Posted: Wed Sep 25, 2013 5:35 am
Found my leak, top of the windshield where the rust is. I hate rust..
Re: What did you do to your Subie today?
Posted: Fri Sep 27, 2013 9:50 pm
Decided to finally paint our garnishes and it turned out pretty good!
Re: What did you do to your Subie today?
Posted: Fri Sep 27, 2013 11:41 pm
Plasti-dipped my entire roof to seal my sunroof. Cant see out of it but when summer comes back I can peel it off and open it again. Plasti-dip is the shit
Re: What did you do to your Subie today?
Posted: Sat Sep 28, 2013 12:43 am
replaced my front stock rotors/pads.. Guess I'll put the brake upgrade off a bit longer.
Re: What did you do to your Subie today?
Posted: Sat Sep 28, 2013 8:36 pm
Cylinder leak down test . Video:
http://youtu.be/iDpNusbxcgs
http://youtu.be/iDpNusbxcgs
Re: What did you do to your Subie today?
Posted: Sun Sep 29, 2013 8:10 am
Reminds me of when I did mine, this makes our cars look even more alike haha. Considering a light bar sometime soon? xDalexandermf wrote:
Re: What did you do to your Subie today?
Posted: Sun Sep 29, 2013 9:45 pm
Painted rims,rotors and calipers black, spoiler black. Reinstalled the spoiler. Finished the ground mod.wiring in door lights and more 12v power outlets Today.... 
Re: What did you do to your Subie today?
Posted: Sun Sep 29, 2013 11:04 pm
I cleaned the interior & washed the exterior of the Impreza and washed the exterior of the Legacy this weekend. Of course it rained after washing the cars. The Lego stayed dry in the garage though 
Re: What did you do to your Subie today?
Posted: Sun Sep 29, 2013 11:07 pm
In the last week I plasti-dipped my grill and windshield wipers, changed my oil, got an OBX crank pulley installed with new Gates drive belts, got new OEM front lower ball joints installed, and installed a new Denso alternator (mine was dying out).
Re: What did you do to your Subie today?
Posted: Wed Oct 02, 2013 6:00 am
Alternator went out, already got it replaced.
Re: What did you do to your Subie today?
Posted: Fri Oct 04, 2013 3:28 am
Painted my black trim+chrome around my car with semi-gloss black spray paint. Hope it holds up through the winter.
Re: What did you do to your Subie today?
Posted: Sun Oct 06, 2013 3:24 pm
Got my timing belt & seal replacement operation well underway today (finally!)
Cracked my crank pulley bolt loose with the starter and a breaker bar resting on the car:
As far as I could tell, the crank pulley bolt didn't shear from this action. (please feel free to check out the detail photos in the linked post below to see the bolt and the bolt hole in case you think you can help identify if this is not the case)
Bonus, my non-impact 22mm socket did not crack or chip at all during this process as I thought it might!
Anyway...long story short, what I thought would work (in my head planning to use 5th gear and a friend standing on the brakes to allow me to crack loose the cam pulley bolts before timing belt removal) won't (automatic transmission)
So... I reckon I could use the same starter trick to crack loose the cam pulley bolts:
^^^ .....no?
Would this be a terrible, horrible idea? And why? They aren't reverse-threaded or anything ridiculously dumb like that, are they? Can I do this?
Link to detail post
Cracked my crank pulley bolt loose with the starter and a breaker bar resting on the car:
As far as I could tell, the crank pulley bolt didn't shear from this action. (please feel free to check out the detail photos in the linked post below to see the bolt and the bolt hole in case you think you can help identify if this is not the case)
Bonus, my non-impact 22mm socket did not crack or chip at all during this process as I thought it might!
Anyway...long story short, what I thought would work (in my head planning to use 5th gear and a friend standing on the brakes to allow me to crack loose the cam pulley bolts before timing belt removal) won't (automatic transmission)
So... I reckon I could use the same starter trick to crack loose the cam pulley bolts:
^^^ .....no?
Would this be a terrible, horrible idea? And why? They aren't reverse-threaded or anything ridiculously dumb like that, are they? Can I do this?
Link to detail post
Re: What did you do to your Subie today?
Posted: Sun Oct 06, 2013 10:04 pm
Finally finished all the ECU related wiring changes to run my rob tune ECU on my EJ20G using the stock harness. I REALLY wish I had just did a 5spd swap and rob tune on the EJ22T with the 2ch ignition converter. Would have been sooooooooooo much easier. I already had everything needed to do it that way... but oh well, its almost done now.
Re: What did you do to your Subie today?
Posted: Mon Oct 07, 2013 7:10 pm
-Changed my oil at work last week. Was bout time I did that!
-Joe
-Joe
Re: What did you do to your Subie today?
Posted: Tue Oct 08, 2013 6:40 am
Put an additional 150miles on me engine today. Now at 550miles, no smoke, no timing issues, and drives good. Installed the boost controller and got it to 15lbs for now. Waxed the car for an additional 5hp. Feels and looks tits.
Re: What did you do to your Subie today?
Posted: Fri Oct 11, 2013 7:53 am
Swapped the 6.5 inch front speakers for 5.25 inch ones. The 6.5 inch ones wouldn't clear the windows.
Re: What did you do to your Subie today?
Posted: Sat Oct 12, 2013 7:19 am
Installed a Yakima Roof Rack
Re: What did you do to your Subie today?
Posted: Mon Oct 14, 2013 10:47 pm
Replaced all of the bolts and studs on my TD05. Didn't take that long, but not very fun doing it with the Turbo on the car. Car is getting VERY close to being able to be fired up!
Re: What did you do to your Subie today?
Posted: Mon Oct 14, 2013 11:46 pm
Did an oil change and switched to full synthetic from semi synth. Now for the rest of the tune up on friday
Re: What did you do to your Subie today?
Posted: Tue Oct 15, 2013 2:35 am
Replaced the broken power antenna with a normal non power one.
Re: What did you do to your Subie today?
Posted: Tue Oct 15, 2013 9:46 pm
94EJ22 wrote:Installed a Yakima Roof Rack
Is that the NA bumper for post face lift? What did you use for fog lights?
Re: What did you do to your Subie today?
Posted: Wed Oct 16, 2013 12:42 am
He has the OEM fog lights. I'm pretty jealousoriginalcyn wrote:94EJ22 wrote:Installed a Yakima Roof Rack
Is that the NA bumper for post face lift? What did you use for fog lights?
Re: What did you do to your Subie today?
Posted: Wed Oct 16, 2013 1:57 am
-Raced my car in a SCCA event at PPIR (Pikes Peak International Raceway) on Sunday. So much fun!
-Joe
-Joe
Re: What did you do to your Subie today?
Posted: Wed Oct 16, 2013 5:41 am
I was going to say that they fit very well.Danny-G wrote:He has the OEM fog lights. I'm pretty jealous
Danny, knowing your affinity for lights, i'm surprised you don't have a set or two.