Page 1 of 1
Aftermarket BOV for the AWIC?
Posted: Wed Oct 26, 2005 5:32 am
by LaureltheQueen
What will work, and actually hook up correctly? My bov currently resides directly over my turbo, so I'm expecting it to go out rather soon
Posted: Wed Oct 26, 2005 5:47 am
by vrg3
I'm using a Bosch blowoff valve from a Saab 9000. It's cool because there are lots of options in the same form factor, and replacements are fairly cheap.
The Bosch valve's fittings are about 1" in diameter, so I slipped some 3/4" heater hose with a 1" OD over the 3/4" fittings on the rubber compressor inlet elbow and the plastic compressor-to-intercooler pipe.
Then I got a molded 1" radiator hose that had a short straight segment and also a 90-degree bend in it. I used these two segments to plumb the Bosch BOV in.
It now looks like it was supposed to be there. I'll try to take pictures in the morning.
Posted: Wed Oct 26, 2005 6:08 pm
by Legacy777
Yeah, I'd be interested in this too.
thanks
Posted: Thu Oct 27, 2005 2:39 am
by THAWA
Why do you think it will die? Aren't they setup this way on Legacys and Libertys with the AWIC, and Imprezas up to and including version 2?
Posted: Thu Oct 27, 2005 2:45 am
by vrg3
Yeah... but without the chimney, the heat will indeed cook the blowoff valve eventually.
I didn't have a chance this morning to get the picture. I'll try again tomorrow.
Posted: Thu Oct 27, 2005 3:07 am
by Legacy777
Just curious....what does the stock piping/bypass look like on the liberties that had the AWIC?
Posted: Thu Oct 27, 2005 3:45 am
by vrg3
It's very simple, short, and direct.
The blowoff valve is stuck into the rubber compressor inlet elbow and a short piece of straight hose goes from the valve to the fitting on the intercooler inlet pipe.
You can see it in this picture:
http://www.graphics.cornell.edu/~v/pics/ej20g_side.jpg
Note that the angle of the BOV fitting on the compressor inlet elbow is different on EJ20Gs. With an EJ22T inlet elbow, you'll need an S-shaped hose if you want to do it that way.
Posted: Thu Oct 27, 2005 4:10 am
by vrg3
I have to leave for work before the sun rises tomorrow, so I just went and took a crappy picture just now:
http://www.graphics.cornell.edu/~v/pics ... v_awic.jpg
I suppose it might not fit so great depending on how you deal with PCV.
Posted: Thu Oct 27, 2005 10:06 pm
by scoobiedoo22
Snowjob had one of his vf11/awic setups for sale and posted a good pic of the complete assembly piping/bov.
http://bbs.legacycentral.org/viewtopic. ... highlight=
John
