legacycentral bbs

Posted: **Fri Jun 02, 2006 2:28 pm**

Out of interest, is it possible for me to pull out/take off an transfer case from Legacy 4WD gearbox that has Lo Range (Hi/Fulltime 4WD) on it from a buggered (blown teeths in G/B 3rd gear?) dual range gearbox and fit it on end of Single Range AWD gearbox transmission that is on my 1995 Liberty?
Cheers
AP

Posted: **Fri Jun 02, 2006 5:05 pm**

I'm not sure about the EJ dual range gearbox (we dont get them here in the the US

), but in the older EA gearboxes the dual range in not a separate "transfer" case, its inside the gear box built into the input shaft.

Gary

Posted: **Fri Jun 02, 2006 6:52 pm**

Cool pic.....haven't seen the inside of a subie dual range box.

Posted: **Tue Jun 20, 2006 11:28 am**

The answer is no, Dual Range EJ Series Gearboxes are simular to EA series. Found out recently after reseaching, and located Dual Range EJ gearbox. Hi & Lo lever is same place on EA series.
Cheers
AP

legacycentral bbs

Transfer case - Dual Range 4WD

Transfer case - Dual Range 4WD