Page 1 of 1
intercooler clamps
Posted: Thu Apr 26, 2007 6:12 am
by 92ss satinsvoice
hay yall im thinking on doing my front mount pretty soon and was wondering what kind of clamps i should use.
the phillps worm screw type. you think they will hold boost without coming un done? or the more expesnsive t-bolt type?
im just thinking ahead.
Posted: Thu Apr 26, 2007 6:17 am
by 555BCTurbo
T-bolts are best...but they are spendy...and the standard hose clamps should work fine for the amount of boost you will be putting through it
Posted: Thu Apr 26, 2007 10:48 am
by BAC5.2
How much boost are you running?
Some people don't have a problem with standard worm-type. Some do. I'd use worm-type clamps.
Are your intercooler pipes bead rolled?
Posted: Thu Apr 26, 2007 5:56 pm
by thehookeup
spend some money and get the t bolts. if you look hard enough online and ebay you can find good deals on them. if you dont got the dough, you better have something for the worm gear clamps to butt up against.
You can always drill 3 or 4 holes at the end of each pipe and then put in tiny screws. its a good cheep alternative to having the pipes rolled or beads welded on.
Posted: Thu Apr 26, 2007 6:37 pm
by Imprezive
T-Bolts for sure. Check out atpturbo.com. They accept paypal which is cool.
If you are clamping around high heat, such as the compressor outlet I'd recommend a spring loaded t-bolt clamp like the ones here
http://turbohoses.com/Clamp.htm.
Posted: Thu Apr 26, 2007 8:09 pm
by biggreen96
well just last night I blew my system apart in the passenger fender @ 16 psi. I think I'm going to go get some t-bolt clamps. The worm screw type is easy to strip getting them tight.
Posted: Fri Apr 27, 2007 1:08 pm
by BAC5.2
Plus, worm clamps cut silicone hoses.
Posted: Sat Apr 28, 2007 6:40 am
by 92ss satinsvoice
well right now im only running 6psi. but once i install my boost controller. front mount and fuel cut defender. im setin it at 15psi.
Posted: Sat Apr 28, 2007 9:09 am
by thehookeup
are your pipes beaded or not?
has anyone used the hair spray method in addition to?
Posted: Sat Apr 28, 2007 6:00 pm
by Threshld1
www.mcmaster.com search t-bolt clamp
Posted: Sat Apr 28, 2007 11:17 pm
by 92ss satinsvoice
my pipes are mandral bent. not crush. there 2.25 or 2.5 inch. cant remeber.
Posted: Sun May 06, 2007 3:47 pm
by New92
www.siliconeintakes.com
Super fast delivery and the best prices ive found so far.
Ben
Posted: Mon May 07, 2007 5:42 am
by 93forestpearl
Using decent T-bolts with non-beadrolled edges, I didn't blow a coupler untill a boost overrun to 24psi. I'm gonna bead roll the pipes, but I gotta get roun-tuit.
If your pipes don't fit together the best, or are trying to bend the coupler in a funny way, you're more apt to popping them. You want as little stress on them when you clamp them down. I have one that is pretty jacked, but hasn't gone anywhere do to the rolled edges.