ej22t, 2.5L crank, pauter rods, 12mm oil pump

wrxzzz · Post by **wrxzzz** » Fri Aug 24, 2007 12:04 am

Selling my project motor:

ej22t closed deck, split crank case with piston squirters. 80K before pulling motor.

phase1, 2.5L crank and pauter rods.

12mm oil pump, ported and shimed.

Hard to find service manual with all tech specs needed to build

All you need are a set of wiesco pistons that are off the shelf made for this stroker combo. They retail about $435. Or you can get some darton sleaves and custom pistons for a monster motor. I hate to sell it but the subie has to go along with the project motor.

$1200 with pick up or you pay shipping. Shipping should not be too bad as these aluminum short blocks are fairly light and compact. I'm in Louisville Kentucky. IM if interested. Thanks

Saskatoon Subaru · Post by **Saskatoon Subaru** » Fri Aug 24, 2007 12:44 am

shtbxr22 · Post by **shtbxr22** » Fri Aug 24, 2007 2:52 am

I shipped an entire short block last year through UPS, and it cost about $78. not too bad. NH to TX.

wrxzzz · Post by **wrxzzz** » Sat Aug 25, 2007 7:58 pm

bump...

wrxzzz · Post by **wrxzzz** » Sun Aug 26, 2007 5:46 pm

wrxzzz · Post by **wrxzzz** » Wed Aug 29, 2007 3:12 am

bump...

Arctic Assassian · Post by **Arctic Assassian** » Sun Sep 02, 2007 7:27 am

shipping to 99507. I would likey very mucho.

Arctic Assassian · Post by **Arctic Assassian** » Mon Sep 03, 2007 9:11 am

hello, you have a buyer.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

ej22t, 2.5L crank, pauter rods, 12mm oil pump

ej22t, 2.5L crank, pauter rods, 12mm oil pump