ej22t, 2.5L crank, pauter rods, 12mm oil pump
Posted: Fri Aug 24, 2007 12:04 am
Selling my project motor:
ej22t closed deck, split crank case with piston squirters. 80K before pulling motor.
phase1, 2.5L crank and pauter rods.
12mm oil pump, ported and shimed.
Hard to find service manual with all tech specs needed to build
All you need are a set of wiesco pistons that are off the shelf made for this stroker combo. They retail about $435. Or you can get some darton sleaves and custom pistons for a monster motor. I hate to sell it but the subie has to go along with the project motor.
$1200 with pick up or you pay shipping. Shipping should not be too bad as these aluminum short blocks are fairly light and compact. I'm in Louisville Kentucky. IM if interested. Thanks
ej22t closed deck, split crank case with piston squirters. 80K before pulling motor.
phase1, 2.5L crank and pauter rods.
12mm oil pump, ported and shimed.
Hard to find service manual with all tech specs needed to build
All you need are a set of wiesco pistons that are off the shelf made for this stroker combo. They retail about $435. Or you can get some darton sleaves and custom pistons for a monster motor. I hate to sell it but the subie has to go along with the project motor.
$1200 with pick up or you pay shipping. Shipping should not be too bad as these aluminum short blocks are fairly light and compact. I'm in Louisville Kentucky. IM if interested. Thanks