legacycentral bbs

I'm putting a new clutch/flywheel in a 91 SS and everything on the transmission is unbolted and it's loose with about a 3/4" gap all the way around between the tranny and engine. It's wiggling around looking like it's ready to just pop off, but nothing. It will move out more with some good yanking and a pry bar and then just suck back in and stay at the 3/4" spot.

Any ideas??

Thanks, Jason

Did you remove the clutch fork pivot?

Here is a link on how to do it
http://bbs.legacycentral.org/viewtopic. ... ing+tranny

Holy crap, thanks! Guess I'm not the only one. I tried to search for it but wasn't really sure what to search for--I'm an ass.