Page 1 of 2
FS: 1991 Turbo Legacy Parts - Stock Brake System Parts
Posted: Fri Nov 23, 2007 12:36 am
by mike270
All parts are off a 1991 Turbo Legacy with ~167k miles. These parts are coming off a stage rally car, but most parts have only seen a few hill climbs under competition.
---- Stock Turbo Legacy Front Calipers - $25/pair+ shipping
---- Stock Brake Master Cylinder - $30 + shipping – Works great, good condition, replaced it when going to my new brake setup.
---- Stock Brake Proportioning Valve - $10 + shipping – In good working condition.
---- Stock Bosch ABS Unit - $30 + shipping - This is the ABS unit just behind the passenger headlight.
Pictures can be provided upon request. All prices are negotiable, so if you are interested, make me an offer!
Posted: Fri Nov 23, 2007 2:31 am
by greg donovan
do you have the ABS sensors?
when i swapped spindles the ones on my car broke and the sensors on the replacement spindles had the wires cut.
Posted: Fri Nov 23, 2007 3:17 am
by mike270
Unfortunately not, I cut the wires and had to hammer them out of the hub as well.
Posted: Fri Nov 23, 2007 6:27 am
by greg donovan
mike270 wrote:Unfortunately not, I cut the wires and had to hammer them out of the hub as well.
i figured as much. mine were in such bad shape i am amazed they still worked.
i think new is going to be the only way to go for these.
i dont really miss the ABS enough to spend 200+ on a pair of sensors.
Posted: Fri Nov 23, 2007 8:59 am
by denver_whitest185
where in colorado are you?
Posted: Fri Nov 23, 2007 6:33 pm
by mike270
PM replied...
Wheels are pending sale...
Posted: Mon Nov 26, 2007 4:22 am
by mike270
Wheels are gone. Bump for everything else.
Posted: Mon Nov 26, 2007 8:28 pm
by Legacy Rally Guy
greg donovan wrote:mike270 wrote:Unfortunately not, I cut the wires and had to hammer them out of the hub as well.
i figured as much. mine were in such bad shape i am amazed they still worked.
i think new is going to be the only way to go for these.
i dont really miss the ABS enough to spend 200+ on a pair of sensors.
Yeah, I've been able to remove two of my four without damaging mine... I did however ruin one.. Upon reinstall, I put them in with anti-seize.. hehe if there's a next time...
Oh and Subaru sells them for $130-$160 I believe.. But yeah, I've got two good ends I picked up from a doner car, I'm going to try to keep the proper length when I install a new end, trying to attempt saving some dough.
My only worry is that there may be a tight tolerance for inductance... Any shorter/longer and it'll start to change with the wires being a "twisted pair"... But I've two good ends, so it's worth a few hours of my time to save that much dough...
Posted: Mon Dec 03, 2007 4:00 pm
by mike270
bump...
Posted: Mon Dec 03, 2007 5:22 pm
by 93Leg-c
PM sent
Posted: Tue Dec 04, 2007 3:14 am
by mike270
PM replied!
Posted: Sat Dec 08, 2007 8:47 pm
by mike270
bump
Brake booster pending...
Posted: Sat Dec 15, 2007 7:00 pm
by mike270
bump...
As mentioned above, all prices are NEGOTIABLE, so if you are interested, make me an offer.
Posted: Sat Dec 22, 2007 3:26 am
by mike270
Brake booster is gone, everything else listed is available!
Posted: Sun Dec 23, 2007 5:38 am
by mike270
Rotors and pads are pending!
Posted: Sun Jan 06, 2008 3:17 am
by mike270
Rotors and pads are gone!
Posted: Fri Feb 29, 2008 4:39 pm
by mike270
Axles are gone, bump for everything else.
Posted: Sat Mar 01, 2008 6:44 pm
by Boostedballs
How much to ship trans to 97113 Oregon?
Posted: Sun Mar 02, 2008 10:26 pm
by mike270
PM sent...
Posted: Mon Mar 03, 2008 5:07 am
by mike270
Rear calipers sold.
Posted: Sat Mar 08, 2008 6:39 pm
by mike270
Clutch master cylinder sold...
Everything else listed is still available!
Posted: Sun Mar 16, 2008 1:04 am
by mike270
Bump...someone has to need this stuff!!! Make me an offer!
FYI, shipping costs on the transmission seem to be roughly $200-$225 from the various methods I've researched.
Posted: Tue Mar 25, 2008 5:33 am
by mike270
Trans pending...
Posted: Thu Apr 10, 2008 3:16 pm
by mike270
Nevermind the earlier post, trans is still available. If interested, make me an offer!
Posted: Mon May 12, 2008 6:45 am
by marke190
Trans still available?