legacycentral bbs

this intake will run down to the fender for cold air. it is all 3 i.d ss 316L and will open to a 4" k&n cone filter.

it will free up alot of room and hopefully generate some ponies.

pipe will be cut to length

Nice. I'm pretty close to doing this myself, only I probably won't have the fancy SS, just aluminum.

Looks really good so far!

i need to machine the maf face still. and weld an elbow to the back end of the maf pipe. it's going to take some fitting and cutting and blood to get it fitting perfect. i also run a bov now so i need to weld a loonie or something over that nozzle that would have been for my bpv return.

i want to keep the filter high in the fender to keep it dryer.

should be done within a month.

that f pipe needs to be modded as well

any pics of this installed ???

damn, you never cease to amaze me, not only do you have bomb ideas, but you put them to work, AND it always ends up looking good. DAMN YOU! haha jk

this is actually on mike from revtronix's car now. well, part of it is. i'll have pics when i finish my intake in the next couple weeks.

thanks Matt

Ryan