legacycentral bbs

Posted: **Tue Nov 24, 2009 7:22 pm**

I got the 2 roll pins out, but the linkage wont come off the shaft. Its been drenched in PB and I bashed on it last night and today and it has not even budged at all.

I'm about to break out the torch, but I figured I check if anyone has any tips/tricks to getting this thing off the car.

Trans still on the car. 45F outside, cold cement.

Posted: **Tue Nov 24, 2009 8:15 pm**

Success! The trick: get really @#$%ing pissed and hit the thing so damn hard you probably bent something in the trans.

Posted: **Tue Nov 24, 2009 9:02 pm**

oooo thats pretty @#$%ing pissed! lol

Posted: **Wed Nov 25, 2009 1:54 am**

lol Yup I knew it would go if you hit it hard enough. Sucks that it's still in the car. I thought you said you had the tranny out?

Posted: **Wed Nov 25, 2009 2:45 am**

Nah its still in the car

And now I cant get the tail housing off....if its not one thing......

I cant find spot on the tail housing to give it a good whack.

legacycentral bbs

Trick to removing shift linkage?

Trick to removing shift linkage?