Page 1 of 1
cat converter question
Posted: Sun Feb 20, 2011 3:15 am
by 1-3-2-4
I'm trying to figure out where something is not right.. this is a replacement rear cat from bosal and the donut gasket is a dealer part.. now i take it the gasket should slide down on the converter right? it seems like it's too thick to do so by like 2mm..
what should I do?
Re: cat converter question
Posted: Wed Feb 23, 2011 3:00 am
by Legacy777
Is the pipe coming out the converter at an angle? I don't believe it should be like that. You sure you got the correct part?
Re: cat converter question
Posted: Wed Feb 23, 2011 3:18 am
by 1-3-2-4
don't matter now car is totaled.
it was for a 95 legacy cat to midpipe
Re: cat converter question
Posted: Wed Feb 23, 2011 3:49 am
by Legacy777
That sucks dude....I keep trying to catch up and run across your posts.
What happen to your car....
Re: cat converter question
Posted: Wed Feb 23, 2011 4:09 am
by 1-3-2-4
car slid over into another lane and a plow truck was going the other way it hit pretty hard..