Page 1 of 1
Need some help with fitting my version 3 TMIC
Posted: Thu May 10, 2012 3:40 am
by mx4life
I swapped a Ver3 RA/STi engine and trans into my legacy. Need to make the Y-pipe longer. What should I use or build it out of? Looking for an easy durable solution. Any help is appreciated.
Re: Need some help with fitting my version 3 TMIC
Posted: Fri May 11, 2012 1:18 am
by BSOD2600
Checked the sticky in this forum for ideas?
build forum also has lots of ideas from members cars.
Re: Need some help with fitting my version 3 TMIC
Posted: Fri May 11, 2012 4:16 am
by mx4life
Ya, I wanna build something that will reach the turbo. didnt really get any ideas unless I overlooked a thread. But this is what im dealing with. the bottom pic is a test fit
Re: Need some help with fitting my version 3 TMIC
Posted: Tue Jul 03, 2012 12:15 am
by DevC
I have the same issue with my 02 wrx ic, I'm going to get a slicone e-bay y pipe and extend it by cutting it and adding a small section of pipe.