legacycentral bbs

I need some ideas. I am ready to do my swap, but cant decide which way to go. Am I able to just use a samco 90 with t clamps?

Thanks a lot, open to all ideas.

Robert

yes, try to order a reinforced tight radius 90.

Which one of these 90's should I order?

http://www.samcosport.com/usa/rp_standa ... #standard2

Would this work?

http://www.spectreperformance.com/#CATALOG.9298

Or this?

http://www.sfxperformance.com/parts/SPT8791.htm

The metal one wouldn't work, but that second one might work.

This is my TD04 setup, the aluminum piping is Spectre Performance with a 90 degree reducer silicone to the turbo.



http://bbs.legacycentral.org/viewtopic.php?f=1&t=49555

What are the measurments of the metal piece? 3in to 2 1/4?

Both tubes are 3" in diameter and the straight is 4" in length and the 90 is just the mandrel bent one not the welded one you had shown. But I believe that the Silicone reducer is 3-2.25" and the black silicone is a flex hose that allows i think 20 degrees of movement.

What did you do with your f pipe and the other plastic pipe with one whole out to two? I just extended to crank case one, so its about 6 in tall vs 1in haha. I like the idea of having that black silicone piece. Where did you get the mandrel bend from? i have a resenator delete in the making, so ill pass on the 4in straight pipe, but id like to hear more about the rest of your set up.

do you have a bulid thread? Also, is your bov hooked up to where the stock bpv used to be under the old plastic intake pipe?

Under my pic is a link to my write up if you will, but here it is again.

http://bbs.legacycentral.org/viewtopic.php?f=1&t=49555

Is the td04 2 1/4 od? There for id need to buy a silicone 2 1/2 id correct?