08 Legacy 5mt Speedo help
Posted: Sat Jul 07, 2012 3:56 am
So, I bought a 08 Legacy Outback 5mt 4.11 a couple months ago for my newest SS build. Well, I'm wrapping up the car right now and did not even think about how the speedo cable was going to install since the newer trans works off a speed sensor. I've been searching around and am getting conflicting information. Some say you can just remove the vehicle speed sensor on the transmission and a cable will screw right in, then others are saying you have to crack the case to install a speedo gear which I am not willing to do
(will void warranty). I will return the transmission to my work for an older 4.11 5mt before I go ripping into the current trans. To add to it, I bought an ACT lightweight flywheel and stage II clutch for this setup so if I do go older, it would have to be a push hydro clutch as well so I can utilize the clutch/flywheel. So, can anyone tell me how the 08 trans would be able to use a speedo cable and if it can not be done without cracking the case, what slightly older trans are capable of just removing the speed sensor and screwing in a cable.
(will void warranty). I will return the transmission to my work for an older 4.11 5mt before I go ripping into the current trans. To add to it, I bought an ACT lightweight flywheel and stage II clutch for this setup so if I do go older, it would have to be a push hydro clutch as well so I can utilize the clutch/flywheel. So, can anyone tell me how the 08 trans would be able to use a speedo cable and if it can not be done without cracking the case, what slightly older trans are capable of just removing the speed sensor and screwing in a cable.