Page 1 of 1
using a na intake wiring harness for turbo swap
Posted: Mon Jan 27, 2014 5:57 am
by turbo wagon
I was going to use the intake manifold harness from my na ej22 motor for the turbo motor so I can keep it plug and play, also I am running a rob tune Ecu . Is there any problems with that?
Re: using a na intake wiring harness for turbo swap
Posted: Mon Jan 27, 2014 7:45 pm
by Legacy777
You will just need to relocate the coolant temp sensor wiring harness connectors to the driver's side of the harness vs. the passenger side. I did this when I did my turbo engine swap. I just took the wiring loom apart and moved the wires over....there's no need to cut and splice anything.
Re: using a na intake wiring harness for turbo swap
Posted: Fri Feb 07, 2014 3:09 am
by legsportwag
Also ground plug is different for 92-94 cars. Turbo is round na is square