Check engine light
Posted: Sat Jun 14, 2014 6:33 pm
I read my codes and all but I was wondering if it's ok to leave the black connectors unplugged or do you have to have them together?
legacycentral bbs
A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans
https://bbs.legacycentral.org/
Check engine light
Page 1 of 1
Re: Check engine light
Posted: Sun Jun 15, 2014 2:46 am
When driving around normally you leave them unplugged.
Re: Check engine light
Posted: Sun Jun 15, 2014 5:58 am
The black ones like I said correct? Because they were plugged in when I got under there
Re: Check engine light
Posted: Sun Jun 15, 2014 7:07 am
There are two black ones under the dash. One set with a stripe and smaller connector, those stay plugged in. The all black ones stay unplugged.
Re: Check engine light
Posted: Sun Jun 15, 2014 4:29 pm
+1 and the ECU code-reading plugs should be just one wire on each connector. The other one is part of the seat belt lights and/or warning (I was just messing w/this last week!).
TD
TD
Re: Check engine light
Posted: Mon Jun 16, 2014 3:56 am
Is this why my seatbelt light has been flashing ever since my swap?wtdash wrote:The other one is part of the seat belt lights and/or warning (I was just messing w/this last week!).
TD
Re: Check engine light
Posted: Mon Jun 16, 2014 4:08 am
^ Probably...mine got unplugged and was blinking, too.