Shaking steering

Struts, spring, anti-rollbars, braces and the like.

Moderators: Helpinators, Moderators

Post Reply
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Shaking steering

Post by IronMonkeyL255 »

I've had a problem for a while now, but recently it's gotten worse.

When turning left at low speeds (parking lot speeds), my steering is REALLY rapidly shaky while turning. It seems to have power assist the entire time, but it just feels SOOO not right.

At higher speeds, there is nothing.

Does anyone have any idea what could be causing this? Is it the p/s pump? The rack itself?
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
Manarius
Fourth Gear
Posts: 1755
Joined: Fri Jul 22, 2005 10:53 pm
Location: USA, PA, Grantham (near Harrisburg)
Contact:

Post by Manarius »

Well, it could be one of two things. If it's car shuddering, I think it's probably torque lock. Only way to fix that: Expensive.

Other thing: Low RPM. My car, when at low RPM, will shudder in the steering when going around corners. Solution: Take corners faster :twisted:.

But seriously, I think it's a matter of the engine not turning fast enough to run power assist.
Last edited by Manarius on Mon Aug 29, 2005 4:04 am, edited 1 time in total.
Manarius wrote:The Neo-Cons would call me a defeatist. I'd call me a realist. I'm realistically saying that a snowball has better chances in the blazes of hell than democracy has in Iraq.
1995 Polo Green Subaru SVX (189k miles - 08/2007-Present)
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Post by IronMonkeyL255 »

It used to not do it, but it got worse since I put in my new steering wheel yesterday......
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Post by IronMonkeyL255 »

Also, it doesn't do it when turning right at the same speeds.

Worn seals perhaps?

Any ideas...?
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
entirelyturbo
quasi-mod-o
quasi-mod-o
Posts: 6000
Joined: Thu Dec 05, 2002 7:06 pm
Location: Tampa, FL

Post by entirelyturbo »

My granpa's wagon is doing this as well, although it only does it when you're going straight, and especially at high speeds.

Check your tie-rod ends, be sure they're in good condition. I need to as well.
"Der Wahnsinn ist nur eine schmale Brücke/die Ufer sind Vernunft und Trieb"

*Formerly DerFahrer*

@entirelyturbo on social media, including Facebook, Instagram, Twitter, and TikTok
Legacy777
Site Admin
Site Admin
Posts: 27926
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Post by Legacy777 »

Do you have an auto or 5spd?

Could be torque bind, could be cv joints....
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Post by IronMonkeyL255 »

auto.
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
Legacy777
Site Admin
Site Admin
Posts: 27926
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Post by Legacy777 »

put in a fuse in the FWD fuse holder, and see if your problem goes away.
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Post by IronMonkeyL255 »

Anything I should check for the tie-rod ends?

What fuse should I use?
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
entirelyturbo
quasi-mod-o
quasi-mod-o
Posts: 6000
Joined: Thu Dec 05, 2002 7:06 pm
Location: Tampa, FL

Post by entirelyturbo »

IronMonkeyL255 wrote:Anything I should check for the tie-rod ends?
Check to be sure the boots are intact, and check that they only rotate in place and don't wiggle around.
"Der Wahnsinn ist nur eine schmale Brücke/die Ufer sind Vernunft und Trieb"

*Formerly DerFahrer*

@entirelyturbo on social media, including Facebook, Instagram, Twitter, and TikTok
Legacy777
Site Admin
Site Admin
Posts: 27926
Joined: Tue Oct 15, 2002 11:37 am
Location: Houston, Tx
Contact:

Post by Legacy777 »

IronMonkeyL255 wrote:What fuse should I use?
Doesn't matter 10-15 amp
Josh

surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT

If you need to get a hold of me please email me rather then pm
IronMonkeyL255
Fourth Gear
Posts: 1902
Joined: Sat Aug 09, 2003 5:02 pm
Location: Woodruff, SC

Post by IronMonkeyL255 »

I'll give that a try.
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.

That being said, everything I post is accurate to the best of my knowledge.

Rio Red '91 Legacy SS
subawhatsubawho
Fourth Gear
Posts: 1443
Joined: Sun Apr 03, 2005 11:08 pm
Location: HELL...A.K.A South Florida
Contact:

Post by subawhatsubawho »

My 90 BJ has the same problem. Does it left or right at low speeds. Fluid is full.

I guess you could call it a stumble.
1991 Legacy BJ L 5MT AWD 189K Paid $100 STOLEN 2/13/06
BAC5.2
Moderator
Moderator
Posts: 9026
Joined: Thu Jan 29, 2004 8:47 pm
Location: Maryland www.andrewtechautomotive.com
Contact:

Post by BAC5.2 »

Ball joints?
2009 Outback 2.5XT. 5MT. Satin White Pearl.
2009 Impreza 2.5i Premium. Blue.

[quote="scottzg"]...I'm not a fan of the vagina...[/quote][quote="evolutionmovement"]This will all go much easier if people stop doubting me.[/quote]
subawhatsubawho
Fourth Gear
Posts: 1443
Joined: Sun Apr 03, 2005 11:08 pm
Location: HELL...A.K.A South Florida
Contact:

Post by subawhatsubawho »

I'm inclined to say it is the pump.

If I sit in my driveway and turn the wheel it will hold for a second...then go limp...then hold...then limp. Like it is playing catch up.

I think I might rebuild the pump with the help of Josh's thread and do a DYI thread with pics just for the sake of this thread and wanting to know.
1991 Legacy BJ L 5MT AWD 189K Paid $100 STOLEN 2/13/06
Kelly
Fourth Gear
Posts: 1286
Joined: Sat Nov 01, 2003 5:35 pm

Post by Kelly »

Bent wheels, bad tires, bad axle.

Which is the most likely to be bad?

If your not sure, swap your rear tires to the front, if it still does it, suspect the axle.
Threshld1
Second Gear
Posts: 529
Joined: Mon Dec 26, 2005 12:53 am
Location: Artic Tundra - MN
Contact:

Post by Threshld1 »

i have something along those lines going on with my 93 ss also. i thought it might be my lose ball joints so im changing them and i find a good amount of play in my wheel bearings. ill let you know if the replacements help any
subawhatsubawho
Fourth Gear
Posts: 1443
Joined: Sun Apr 03, 2005 11:08 pm
Location: HELL...A.K.A South Florida
Contact:

Post by subawhatsubawho »

I narrowed mine down to the P/S pump. I noticed last night when I was doing some work on it that the pump is making a loud whinning noise.

Anything making this kind of noise can not be working at 100% (IMO
1991 Legacy BJ L 5MT AWD 189K Paid $100 STOLEN 2/13/06
0perose
Third Gear
Posts: 717
Joined: Thu Dec 16, 2004 5:26 pm
Location: Potsdam, New York

Post by 0perose »

resolutions on this???

my car's been doing it for a while
yo mang, can I get a rootshell?

1991 N/A, 4eat, crazy lights, junk suspension, sticker wagon
1989 xt6 work in progress
Post Reply