2006 wrx intercooler.. pressure tested?

legacy22t · Post by **legacy22t** » Tue Oct 03, 2006 5:20 pm

Does any one know what the 2006 wrx intercooler is pressure tested to ? Or how much boost you can run on this intercooler?

azn2nr · Post by **azn2nr** » Wed Oct 04, 2006 5:14 am

push it till it pops. most intercoolers will hold up to more than youll be able to give it

Bheinen74 · Post by **Bheinen74** » Sun Oct 08, 2006 7:14 am

i just made arrangements to get the 06WRX intercooler (non Sti version) This will be my virgin attempt at intercooling. might not get to it til next spring. Going on my 92 ss 5spd, which is getting new 04 WRX flywheel and oem clutch. Has STi axleback now, K&N, and boost guage soon to go in as well. After i run it with boost guage to determince accuaracy of the guage, i will install intercooler, then MBC. yeah OH, oem VF11......

rallysam · Post by **rallysam** » Tue Oct 10, 2006 7:25 pm

The intercooler will be able to hold pressure. Think about it - the metal intercooler can certainly hold a lot more pressure than all those crappy, clamped, rubber and plastic hoses in your engine compartment.

Imprezive · Post by **Imprezive** » Wed Oct 11, 2006 5:48 am

I believe the '06 wrx intercooler has plastic endtanks. But yeah, I'm sure it, and pretty much any other intercooler could handle anything you could dish out.

legacy22t · Post by **legacy22t** » Wed Oct 11, 2006 3:43 pm

The 06 intercooler has plastic ends .. and l plan on beating it as much as possible. l was just curious if there were any specs out there, Thanks all. l'll be posting all my changes to my ride as soon as possible.

Imprezive · Post by **Imprezive** » Wed Oct 11, 2006 5:32 pm

sweet. But, what are your aspirations boost wise? I mean, I dont think you will be beating the IC so much as beating your turbo

legacy22t · Post by **legacy22t** » Wed Oct 11, 2006 7:12 pm

Well that l haven't quite figured out yet..for now probably about 15 psi, but l am going to a wrx turbo with about 10000km on it. l am also changing the fuel pump, downpipe, 3 inch exhaust( l am going to try a flowmaster ...want to see what it sounds like), act lightened flywheel , wrx cluch kit, boost guage, manual boost controler, timing belt, and various other parts l can't think about write now..oh yeah since l am going faster , brakes.. performance pads and all around crossed drilled rotors( which l got for 180 bucks shipped to my door..from a place in london ,On. sweet!!)
Anyway..

Imprezive · Post by **Imprezive** » Wed Oct 11, 2006 8:46 pm

I see. Sounds good. Somehwat similar to my plans.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

2006 wrx intercooler.. pressure tested?

2006 wrx intercooler.. pressure tested?