If you can source the proper trans, it should bolt in just fine.
You could swap your 3.9 ring and pinion into this also.
'93 Winestone SS Auto, '91 Pearl White SS.
'93 Pure White SS EJ20G slanty intercooled, SIDESWIPED! In stasis.
'94 FWD and '95 AWD Laguna Blue SVXs.
2017 Pure Red BRZ Limited w/Performance pack
You'd have to give up more than just a 'little off the line' if you want this LSD. Different tranny with the correct gears, or change the ring and pinion (not sure if that will work). You can't run different gear ratios in the front and rear.
Im not sure that diff will actually work with our cars, after doing some research into various axle types and such for my own diff swap (STI R180)
Apparently that diff is a direct bolt in to a 2.5RS, and I know from practical experience that legacy axles do not physically fit into RS hubs, they're about 3mm wider
That leads me to believe that if these axles fit an RS, they will be too small for USDM legacy hubs.
LOL I know where youfound that I know where you found that!!!
I almost bought that from JHOT IMPORTS on eBay lol
I couldnt be sure it would work so I didnt buy it.
~Spencer
94 Legacy Turbo (550 Robtune/ej20h v2 Sti RA drivetrain)
94 Legacy Ti Wagon (5mt ej22e)
91 rhd Legacy GT Wagon (factory 5mt, ej20g)
93 rhd Legacy GT type S2 Sedan (4eat, ej20g)
91 rhd Legacy Ti Type S 1.8
03 Lincoln LS V8 Sport
08 300 SRT8