does anyone make a short throw shifter-1990 legacy 2.2

SILINC3R · Post by **SILINC3R** » Sun Jun 01, 2008 4:47 am

i have seen them on ebay for 1993 imprezas but not sure if that would work.

Aerotech · Post by **Aerotech** » Sun Jun 01, 2008 6:00 am

Shifters are all the same for Legacy, Impreza and WRXs, but later cars have an extra u-joint. STI shifter will bolt right in, but you need that extra joint to hook it up...about $60 from Subaru. Any add-on short shift kit that just changes geometry should work, no problem.

Arctic Assassian · Post by **Arctic Assassian** » Sun Jun 01, 2008 6:56 am

I had the understanding you need a full linkage from a newer car to run a short throw shifter. Our design is very different.

555BCTurbo · Post by **555BCTurbo** » Sun Jun 01, 2008 7:21 am

Arctic Assassian wrote:I had the understanding you need a full linkage from a newer car to run a short throw shifter. Our design is very different.

This is more true...

Many of the later units have a backwards U-joint setup...so if you drive out the roll pin on the transmission and change the U-joint...it should work well.

SILINC3R · Post by **SILINC3R** » Sun Jun 01, 2008 5:46 pm

so the one off of ebay for like 30 bucks will work. it is only the shifter. i did not know if they would work so i just took a hack saw to my shifter to shorten it.

Post by **Legacy777** » Mon Jun 02, 2008 5:04 pm

SILINC3R wrote:so the one off of ebay for like 30 bucks will work. it is only the shifter. i did not know if they would work so i just took a hack saw to my shifter to shorten it.

You have to have the matching shifter linkage assembly. So you will need to swap that out as well if you get the ebay shifter.

ciper · Post by **ciper** » Tue Jun 03, 2008 6:30 am

I have a spare u joint if someone wants. Its a common upgrade to buy a new one when installing a better shifter (since they get some play with age)

SILINC3R · Post by **SILINC3R** » Tue Jun 03, 2008 6:37 am

well i am not sure what i need but know i have trouble putting it into reverse and fifth gear

SILINC3R · Post by **SILINC3R** » Wed Jun 04, 2008 7:24 am

well since i have trouble shifting into reverse and fifth gear is that a bushing or what. i would take a picture but do not know how to post

Post by **Legacy777** » Wed Jun 04, 2008 6:23 pm

Email me the pictures.

Chances are the bushings are shot.

SILINC3R · Post by **SILINC3R** » Wed Jun 04, 2008 8:04 pm

i have to replace the right cv axle in the morning tom. so i will take pictures of the shifter.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

does anyone make a short throw shifter-1990 legacy 2.2

does anyone make a short throw shifter-1990 legacy 2.2