what should I do?
cat converter question
Moderators: Helpinators, Moderators
-
1-3-2-4
- Second Gear
- Posts: 308
- Joined: Sun Nov 06, 2005 6:21 am
- Location: Greenwich, Connecticut
- Contact:
cat converter question
I'm trying to figure out where something is not right.. this is a replacement rear cat from bosal and the donut gasket is a dealer part.. now i take it the gasket should slide down on the converter right? it seems like it's too thick to do so by like 2mm..
what should I do?
what should I do?
Re: cat converter question
Is the pipe coming out the converter at an angle? I don't believe it should be like that. You sure you got the correct part?
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
-
1-3-2-4
- Second Gear
- Posts: 308
- Joined: Sun Nov 06, 2005 6:21 am
- Location: Greenwich, Connecticut
- Contact:
Re: cat converter question
don't matter now car is totaled.
it was for a 95 legacy cat to midpipe
it was for a 95 legacy cat to midpipe
Re: cat converter question
That sucks dude....I keep trying to catch up and run across your posts.
What happen to your car....
What happen to your car....
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
-
1-3-2-4
- Second Gear
- Posts: 308
- Joined: Sun Nov 06, 2005 6:21 am
- Location: Greenwich, Connecticut
- Contact:
Re: cat converter question
car slid over into another lane and a plow truck was going the other way it hit pretty hard..