What did you do to your Subie today?

[SILINC3R]

nope lol.

[SILINC3R]

did u use fuel stabalizer??...^^^

nope lol

and i kind of like the white wheels but the GT rims are my favorite. maybe get the white rims painted bronze or somehting

[sqc151]

well after trying on different rims, the GT ones are my favorite to.

my work emotions didnt do it for me. 18.7.5 (chome on white.)

the grids are a friends im borrowing (18x9.5). there nice, but way to wide for my driving style. all 4 of my fenders are rolled and i still rubbed. (on stock struts and springs)

i think when it comes time to get rims it will be a 17x8.5 rim.
the GT wheels i may power coat white after i drop it an inch or so.

[euroshark]

the gt rims in white would be haaawwwt!!!

[SWRT]

I love white on white. And your car is loaded with awesome dude

[SUBYLUV871]

put in a cd player in the wifes car. now i can hear how clapped out her speakers are.

[Danny-G]

Played in a muddy field. So much fun.

[SUBYLUV871]

how long did it take you to roll your fenders?

little busy this morning...

i noticed some noise from the front end. so i put it up on the ramps and made sure my endlinks were tight. both small bolts on each side were a little lose. so tighten em back up, then i lifted the car further in the air to inspect my ball joints, tierod ends and hub bearings. the drivers front wheel felt like it was ablout to fall off. so as im getting ready to swap hubs i noticed i can turn the axle nut by hand. it was broken where u put a notch it in. so i replaced it with a good one i have and now the front end is all tight again.

then got to the fender rolling... did all 4 corners on the 93ss.



then Turbooutback98 from ct drove to my house to swap his catless 3" BPM exhaust for my stock 93 exhaust and up pipe. cleaned up nice i think.





so all in all, had a good morning so far.

[SILINC3R]

Installed my 2nd set of EDM lights on my turbo car, how nice it is to see.

[originalcyn]

Radiator Replacement...

[Falken-18c]

I put my subaru in danger lol. I drove it 80km illegally to get it to a friends shop so i can work on it.
Some things should not be said lol but i dont care lol i got way too much nerve.
when i first got it i just slaped on a set of plates and drove it almost 300km home lol
it gets worse but i said too much lol

[Danny-G]

Had some mile(age) stones today.
First this.

261,993
Then this one.

262,000
Then I went out rallying and found snow at 2100 feet.

And after all that I saw an amazing tail light fix.... lol.

[SUBYLUV871]

i opened my frozen door nice and easy this morning, my wife opened her door with all her might and tore the door seal, then i chewed her ass out. lol

[kimokalihi]

Haha stupid doors with no frames.

[Danny-G]

Got a whole left front knuckle from a junk yard on the 31st. It only cost like 55 bucks with tax and it has all the abs stuff I don't need so that will be coming off when I get the wheel bearing replaced.

[kimokalihi]

Damn that's expensive. I could get two for that price at my local yard. I actually just bought one a few months ago after failing to get my new wheel bearings to seat all the way.

[James614]

Ricer'd it out with an Apexi Power Intake. Also broke and fixed the hose on mystery solenoid above the BCS that apparently plays a huge role in fuel cut.

[sqc151]

how long did it take you to roll your fenders?

about an hr.

[euroshark]

pulled my swap yesterday. started prepping my other motor to go in.

[scoobyadam]

seafoamed, oil change, tranny oil change, rear diff fluid change, and installed a cobb shift knob.

[James614]

Chucked my A/C compressor and lines. Now there's a place for my WRX coolant tank to bolt to, I've probably been pushing it with my zip ties...

[Danny-G]

Took the light bar off and washed it.... Can't see the road at night anymore and its too clean and shiny..

[Danny-G]

Discovered why the drivers door is a bitch to open... Hinges are letting it sag and forcing me to literally punch the door to get it open. Gotta adjust the hinges or door catch this weekend when I have time.

[Falken-18c]

Chucked my A/C compressor and lines. Now there's a place for my WRX coolant tank to bolt to, I've probably been pushing it with my zip ties...

LMAO i dont even have my wrx coolant tank mounted are zip tied lol i just have my lines on tight and its floating lol

i also had my car sideways and every thing it dont leak lines are still on tight but i still dont like it im gunna
be mounting it somtime soon.

[Danny-G]

Lightbar back on!!! So glad to have the Hellas back so I can see the road at night!