My book says to disconnect the one wire plug harness under the lower dash panel. Turn on key and wait for trouble codes to flash. If the connector is not disconnected the CEL will flicker. Well I cant get any codes and if I connect the the one wire harness, I dont get a flickring CEL. Is there something else that I have to do to get the codes? Stumped in Pa.
Thanks,
Joe
Getting trouble codes on 91 legacy
Moderators: Helpinators, Moderators
check out my site for more info and pics on pulling codes. Info is in the notes & tips, engine related.
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
Awsome site!
This is great, That you share your info! Thanks!! I will be referring to your site quite often.
Joe in Pa
Joe in Pa
welcome.
May also want to check out tech info on my site as well, owners manual, factory manual, parts manual.....
May also want to check out tech info on my site as well, owners manual, factory manual, parts manual.....
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm